Toshiba DK 16 manual DK8 and DK16 Voice MAIL/AUTO Attendant Block Diagram

INSTALLATION-PERIPHERALS SECTION 100-816-207 MARCH 1993

DK8 QRCU

OR

DK16 K4RCU

NOTE:

The K4RCU or QRCU allows VM DTMF dialing.

DK8 QSTU (CKT 1 & 2) or

PSTU (CKT 1~8) or

DK16 PESU (CKT 1 & 2)

or

DK16 KSTU (CKT 1 ~ 4)

MDF

VOICE MAIL OR AUTO ATTENDANT MACHINE

25-PIN CABLE

(8 CIRCUITS PER PSTU) (2 CIRCUITS PER PESU) (4 CIRCUITS PER KSTU) (2 CIRCUITS PER QSTU)

QSTU, KSTU/PSTU/PESU CIRCUIT TIP & RING

(1 PAIR PER PORT)

FIGURE 7-22

DK8 AND DK16 VOICE MAIL/AUTO ATTENDANT BLOCK DIAGRAM

•B Tone Signals. Stations send a recall (B) tone to VP whenever Toshiba VP answers a transfer (camp-on) recall from a station that did not an- swer a Toshiba VP blind transfer. (The B tone notifies Toshiba VP that the call is a recall and not a new call, allowing Toshiba VP to respond with the appropriate greeting.) For this feature to operate, the QSTU, PSTU, KSTU, or PESU voice mail ports must have LEDs 19 and 20 turned ON in Program 31.

7.14Toshiba VP Installation. Use the preceding information in concert with Paragraphs 7.23 and

7.24to install Toshiba VP.

7.20Customer-supplied Voice Mail Messaging Systems

7.21STRATA DK8 and DK16 systems are de- signed to support a wide range of customer-sup- plied voice mail messaging systems. Depending on the voice mail system used, some of the features

available with Toshiba VP (refer to Paragraph 7.10) may be available with the customer-supplied sys- tem.

7.22DK8 and DK16 Voice Mail (QSTU, PSTU, KSTU, or PESU Port) Programming Consider- ations

7.23Voice mail (all types) QSTU, KSTU, PSTU, or PESU port programming is accomplished using Programs 31 and 10-2(refer to Programming Procedures, Section 100-816-300, for details). Voice mail (VM) programming features are:

• VM Groups—This feature groups VM QSTU, KSTU, PSTU or PESU ports together so that message waiting set/cancel signals appear to originate from the lowest port in the VM group. All VM ports connected to a particular VM machine should be set in the same VM group (Program 31, LEDs 05 ~ 08).

• Message Waiting Set/Cancel—If the VM ma- chine has the ability to dial a code, plus the appropriate station numbers to set or cancel the message waiting LEDs on electronic telephones,

7-30