Toshiba DK8, DK 16 Table RM-R Type 2 Program Procedure Example, Enter Port Number Or Port Range

REMOTE ADMINISTRATION AND MAINTENANCE PROCEDURES

SECTION 100-816-600

MARCH 1993

TABLE RM-R

TYPE 2 PROGRAM PROCEDURE EXAMPLE

(PROGRAMS: 20, 30, 31, 35, 40, 41, 43, 79, 81 ~ 89)

STEP		ACTION			DISPLAY/PRINTOUT
1	Enter Program Mode			>MODE PROG
	At the >MODE prompt, enter P R O G CR.			P
2	Enter Program Number			P 30
	Refer to the record sheet and enter the desired program number.
	Example: Program 30, enter 3 0, press CR.
3	Enter Port Number	or Port Range	*	P30
	Refer to the System Record Sheet and enter the desired			P30 04
	port number(s). Example: 0 4.
4	Press # button.			P30 04#
5	Enter the Desired Button/LED Number			P30 04# 01 N (Note)
	Example: Button/LED 01, enter: 0 1.
6	To Change Button/LED Status			P30 04# 01 N Y
	Refer to the System Record Sheet and change the button/LED
	status, if required (Y or N).
	Example: Enter Y.
7	To Advance to Next Button/LED
	Press SPACE (repeat Step 6 if necessary).
8	To Review Button/LED Status Change			P30 04# 01 Y- LED "ON"
	Press CR.					Button LED Number
	Re-enter Steps 3, 4, and 5.					Port Number
						Program Number
9	To Exit Program/Store Data			P10
	A) To store data, press CR.			P10 ##
	B) To exit this program, press # #, then press CR.			P
	C) Continue returning to Step 2 until all Type 2 programs
	are completed.
10	To Exit the Program Mode			>MODE
	Press # # CR.
11	To Enter Another Mode,
	Press
	D U M P CR	(data dump)		D
	T E S T CR	(test)		T
	M E S G CR (LCD messages)			(no prompt)
	R E P T CR	(speed dial)		R

NOTE:

Y = button/LED(s) "ON", N = button/LED(s) "OFF"; U = button/LED(s) "ON" some ports and "OFF" other ports.

-27-