Toshiba DK8, DK 16 manual Table RM-P Program Flexible Access Code Numbering

	REMOTE ADMINISTRATION AND MAINTENANCE PROCEDURES
			SECTION 100-816-600
			MARCH 1993
	TABLE RM-O
	PROGRAM 04
	PORT/STATION NUMBER ASSIGNMENT
STEP	ACTION		DISPLAY/PRINTOUT
1	Enter the Program Mode	>MODE PROG
	At the >MODE prompt enter P R O G CR.	P
2	Enter Program Number 04	P 04
	Press CR.	P04
3	Enter the Logical Port Number	P04
	Refer to the System Record Sheet and enter the desired	P04	01
	logical port number.
	Example: Port number 01, enter 0 1.
4	Press # button.	P04
	System displays present station number. Refer to the	P04	01# 11 06
	System Record Sheet and enter the desired station number.
	Example: Station number 16, enter 1 6.
5	To Exit Program/Store Data	P04
	A) To store data; press CR.	P04	01# 11 06
	B) Continue returning to Step 3 until all Program 04	P04	##
	data is entered.	P
	C) To exit this program, press # # CR.

NOTE:

A blank is displayed by "N".

TABLE RM-P

PROGRAM 05

FLEXIBLE ACCESS CODE NUMBERING

STEP	ACTION	DISPLAY/PRINTOUT
1	Enter the Program Mode	>MODE PROG
	At the >MODE prompt, enter P R O G CR.
2	Enter Program Number 05	P 05
	Press CR.	P05
3	Enter Access Code number that you wish to change (0 ~ 9)	P05 4 4
	Example: 4 (if it was not previously changed, the system
	will print another 4. If it has been previously changed,
	the system will print the number to which it was changed).
4	Change the number if required (one or two digits)	P05 4 4 6
	Example: Change to 6, press CR.
5	Continue returning to Step 3 until all required access
	codes have been changed.
6	To Exit this Program	P
	Press # # CR.

NOTE:

Programs 10-1, 10-2, and 10-3use Type 1 procedure.

-25-