Toshiba DK 16, DK8 manual DK16 Piou Relay Control Functional Wiring Diagram, Ddcb Installation

INSTALLATION-PERIPHERALS

SECTION 100-816-207

MARCH 1993

PIOU PCB
SELECT RELAY FUNCTION		PIOU 25 PR.			MDF 66M	PAGE
		CONNECTIONS			BLOCK
WITH PROGRAM 77-1		PIN NO.		COLOR	PIN NO.s	AMPLIFIER
DOOR LOCK OR EXTERNAL
PAGE CONTROL
BREAK						BGM MUTE	DOOR
	DE.T	32	.	R-O	13
P10
	DE. R	7	.	O-R	14		LOCK
							CONTROL
MAKE
			.			TAPE
						PLAYER
BREAK P11			.			CONTROL
	NH.T	34	.	R-Br	17
	NH.R	9	.	Br-R	18
MAKE			.
			.

SELECT RELAY FUNCTION WITH PROGRAM 77-1:

NIGHT RELAY OR

MOH CONTROL

MDF

CONNECTIONS

ALL WIRES SHOULD BE JACKETED 24 AWG TWISTED PAIRS

NIGHT

BELLTO MUSIC-ON- HOLD INPUT

NOTE:

Dotted lines and solid lines differentiate optional connections where applicable; do not connect both options simultaneously.

FIGURE 7-6

DK16 PIOU RELAY CONTROL FUNCTIONAL WIRING DIAGRAM

(Logical Port 04) of the Base Unit Digital telephone circuit set and to circuit 1 of the KCDU or PDKU (Logical Port 12) in the Expansion Unit. Each DDCB door lock control installed reduces the sys- tem door phone capacity of six by one. Any elec- tronic or digital telephone can be equipped with a button for each of the door locks. Install each DDCB door lock control as follows:

DDCB Installation

1)On DK8, connect applicable digital telephone circuit (Logical Port 02 or 03) to the DDCB KSU modular jack (see Figure 7-9 and Figure 8-4).

2)On DK16, connect the applicable digital tele- phone circuit (Logical Port 04 or 12) to the DDCB HKSU modular jack (see Figure 7-9 and Figure 8-4).

3)On the DDCB, set SW1 to the DOOR position, and SW2 to the LOCK position.

4)In Program 77-1, set the door unlock activa- tion for three or six seconds, and enable the applicable port for DDCB connection, and specify if door phones should ring over exter- nal page at night.

5)In Program 77-2, enable the DDCB B-jack for door lock operation, and specify 1 or 5 rings when door button is pressed.

6)In Program 79, specify door phone ringing assignments.

7)In Program 39, assign Unlock Door buttons to the desired stations.

8)Check each Unlock Door button from each station: DDCB modular B-jack (pins 3 and 4) will momentarily close (three or six seconds) when the appropriate Unlock Door button is pressed.

7-8