Toshiba DK 16, DK8 manual Table RM-AH Program Smdr OUTPUT/ACCOUNT Code Digit Length

REMOTE ADMINISTRATION AND MAINTENANCE PROCEDURES

SECTION 100-816-600

MARCH 1993

TABLE RM-AH

PROGRAM 60

SMDR OUTPUT/ACCOUNT CODE DIGIT LENGTH

STEP	ACTION		DISPLAY/PRINTOUT
1	Enter Program Mode		>MODE PROG
	At the >MODE prompt, enter PROGCR	.	P
2	Enter Program Number 60		P 60
	Press CR .		P60
3A	SMDR Threshold Time		P60 21
	Enter: Item code 2.
	The system will display either "0" or "1". "0" indicates that the
	threshold time is set at 0.1 seconds. "1" indicates 10 seconds.
	The default is "1".
	Refer to the System Record Sheet, and enter the correct digit—
	if it is not already being displayed—and then	CR.
	If you wish to change another parameter within this program,
	enter its associated item code. To exit this program, go to step 4.
3B	Allow SMDR printout.		P60 3 1
	Enter: Action code 3.		P60
	System will print out "1" if incoming and outgoing calls will be
	printed on SMDR. A "0" will be printed out if only outgoing calls
	will be printed.
	Refer to the System Record Sheet and change (to 1 or 0), if
	required, and press CR.
	If you wish to change another parameter within this program,
	enter its associated item code. To exit this program, go to step 4.
3C	Set Account Code Digit Length		P60 4 06
	Enter: Item code 4.
	The system will display the number of digits allowed in the
	account code. The default is 06.
	Refer to the System Record Sheet and enter the required number
	of digits (04 ~ 15) and press CR.
	If you wish to change another parameter within this program,
	enter its associated item code. To exit this program, go to step 4.
3D	SMDR Toll Calls Only		P60 5 0
	Enter: Action code 5.
	The system will display the presently selected feature (0 ~ 5).
	The default is 0. Refer to the System Record Sheet and enter the
	required feature code and press CR.
	If you wish to change another parameter within this program,
	enter its associated item code. To exit this program, go to step 4.
3E	Enter DISA ID Code		P60 6 NNNN
	Enter: Item code 6.
	System will display last entered ID code number. Default = Blank.
	Refer to the System Record Sheets, and enter a new code if
	desired, and then press CR.
	If you wish to change another parameter within this program,
	enter its associated item code. To exit this program, go to step 4.
3F	Credit Card Call Digit Length		P60 7 13
	Enter: Item code 7.
	The system will display the current digit length.
	Refer to the System Record Sheet, and enter the desired length,
	01 ~ 30 digits, and then CR. Example: 13 digits; enter 1 3 CR.
	If you wish to change another parameter within this program,
	enter its associated item code. To exit this program, go to step 4.
4	To Exit Program/Store Data		P60 6 NNNN
	Press # # CR.		P60 ##
			P

-38-