Toshiba DK 16, DK8 manual Table RM-Q Type 1 Program Procedure Example

REMOTE ADMINISTRATION AND MAINTENANCE PROCEDURES

SECTION 100-816-600

MARCH 1993

TABLE RM-Q

TYPE 1 PROGRAM PROCEDURE EXAMPLE

(PROGRAMS: 10-1, 10-2, 10-3, 15, 16, 42-0, 77-1, 77-2)

STEP		ACTION		DISPLAY/PRINTOUT
1	Enter Program Mode		>MODE PROG
	At the >MODE prompt, enter P R O G CR.		P
2	Enter Program Number		P 10
	Refer to the record sheet and enter the desired program number.		P10
	Example: Program 10-1, enter 1 0, press CR.
3	Enter Program Code or Digit(s) Per Record Sheet		P10 1
	1 or other digit required.
	NOTE: Most programs do not require a second digit.
4	Enter Button/LED Number		P10 1 01 N		(see note)
	Enter the desired button/LED number.
	Example: Button/LED 01, enter 0 1.
5	To Change Button/LED Status		P10 1 01 N Y
	Refer to the System Record Sheet and change the button/LED
	status, if required (Y or N).
	Example: Enter Y.
6	To Advance to Next Button/LED		P10 1 01 Y
	Press SPACE. Repeat step 5 if necessary.			02 N
7	To Review Button/LED Status Change		P10 1 01 Y-			Button LED "ON"
	Enter CR.					Button LED Number
	Re-enter Steps 3 and 4.					Program Code
	NOTE: This step is optional and not required to save data.					Program Number
8	To Exit Program/Store Data		P10
	A) To store data, press CR.		P10 ##
	B) To exit this program, press # #, then press CR.		P
	C) Continue returning to step 2 until all Type 1 programs
	are completed.
9	To Exit the Program Mode		> MODE
	Press # # CR.
10	To Enter Another Mode
	Press
	D U M P CR (data dump)		D
	T E S T CR	(test)	T
	M E S G CR (LCD messages)		(no prompt)
	R E P T CR	(speed dial)	R

NOTE:

Y = button/LED "ON", N = button/LED "OFF"

-26-