Toshiba DK8, DK 16 manual Program 42-0, Programs 45 ~, Programs 50 ~, Programs 81 ~

INSTALLATION-DK 16 KSU & PCB

SECTION 100-816-205

MARCH 1993

TABLE 5-E

PCOU CONTROLS, INDICATORS, AND INTERFACE CONNECTORS

CONTROL/INDICATOR/
CONNECTOR	TYPE OF COMPONENT	DESCRIPTION
(Figure 5-17)
CO Line Circuit 1	Red LED	Lights to indicate CO line circuit 1 is in
Indicator CD112		operation (NOTE: CO line indicator will
		not light unless PCOU is connected to
		a CO).
CO Line Circuit 2	Red LED	Lights to indicate CO line circuit 2 is in
Indicator CD212		operation (NOTE: CO line indicator will
		not light unless PCOU is connected to
		a CO).
CO Line Circuit 3	Red LED	Lights to indicate CO line circuit 3 is in
Indicator CD312		operation (NOTE: CO line indicator will
		not light unless PCOU is connected to
		a CO).
CO Line Circuit 4	Red LED	Lights to indicate CO line circuit 4 is in
Indicator CD412		operation (NOTE: CO line indicator will
		not light unless PCOU is connected to
		a CO).
J1 Connector	Modular connector	Interface connector for CO line circuits
		1 and 2.
J2 Connector	Modular connector	Interface connector for CO line circuits
		3 and 4.
PAD Switch SW101	Two-position slide	Enables 3dB signal level drop for CO line
		circuit 1.
PAD Switch SW201	Two-position slide	Enables 3dB signal level drop for CO line
		circuit 2.
PAD Switch SW301	Two-position slide	Enables 3dB signal level drop for CO line
		circuit 3.
PAD Switch SW401	Two-position slide	Enables 3dB signal level drop for CO line
		circuit 4.

Program 41

•Assigns stations access to CO lines (outgoing only).

Program 42-0, 1-8

•Assigns behind PBX/CENTREX operation to each CO line.

Programs 45 ~ 48

•Defines Toll Restrictions for any CO line.

Programs 50 ~ 56

•Defines Least Cost Routing using CO lines.

Program 78

•Assigns special ringing of CO lines: Night Ring Over Page, DISA, IMDU.

Programs 81 ~ 89

•Assigns CO lines to ring selected stations.

•Assigns Delayed Ringing to any CO line.

Program 93

•Assigns names to CO lines.

5-27