Toshiba DK8, DK 16 manual Purpose, Organization, Reference Documentation, System MNEMONICS/TERMS

1PURPOSE

1.00The purpose of this section is to provide detailed step-by-step instructions for installing the STRATA DK8 and STRATA DK16 systems.

1.01This chapter provides an overview of the entire installation section, and includes a list of reference documentation that supports the in- stalled system; a list of system mnemonics is also provided.

2ORGANIZATION

2.00This manual is organized in modular chap- ters for easy removal and replacement of updated materials. The chapters are as follows:

Chapter One	-	Introduction
Chapter Two	-	Site Requirements
Chapter Three	-	System Configuration
Chapter Four	- STRATA DK8 KSU and PCB
		Installation
Chapter Five	- STRATA DK16 KSU and PCB
		Installation
Chapter Six	-	Station Apparatus Installation
Chapter Seven	-	Peripherals Installation
Chapter Eight	- System Wiring and Main Dis-
		tribution Frame Arrangements

3REFERENCE DOCUMENTATION

3.00The STRATA DK8 and DK16 digital key systems are supported by the following comple- ment of reference documentation:

3.10General Description: An overview of the STRATA DK8 and DK16 systems and their fea- tures.

3.20Programming: Detailed step-by-step in- structions on how to enter data in the System Record sheets, and how to program the system from the completed System Record Sheets. LCD responses are included to provide clear guidance for the programmer.

3.30User Guides: Detailed step-by-step guides on how to operate digital telephones, electronic

INSTALLATION-INTRODUCTION

SECTION 100-816-201

MARCH 1993

telephones, standard telephones, direct station selection consoles, add-on modules and data in- terface units.

3.40Fault Finding Procedures: Hardware trou- bleshooting and diagnostic information presented in flowchart form.

3.50Remote Maintenance and Administration: Programming and maintenance procedures spe- cially adapted for remote maintenance and admin- istration terminal use. Detailed, step-by-step in- structions are provided, complete with the terminal responses.

4SYSTEM MNEMONICS/TERMS

4.00Mnemonics are used to identify the system’s hardware, operation, and features. The following alphabetical listing describes the mnemonics used in this manual.

ADM: Add-on Module—A telephone upgrade that provides 20 Direct Station Selection (DSS) but- tons with busy LED indication on STRATA DK16 and 10 DSS buttons plus 8 speed dial buttons (one for every station), one night transfer and one all call page button on STRATA DK8. Can be installed on any or all 2000-series Digital Telephones in the system. Attaches to the tele- phone and uses the same port assigned to the telephone. ADM buttons are fixed and cannot be changed in system programming.

BPS: Bits Per Second—Unit of measure that re- fers to the transmission speed (baud rate) of electronic signals. It is used when describing data interface unit and modem operation.

CO: Central Office—The facility which houses switching equipment that provides telephone service (CO lines, Centrex lines, etc.) for the immediate geographical area.

CO Line: A term used to define the STRATA hardware circuit that connects to the Central Office network line pair. Each CO line is as- signed a CO line number in system software.

1-1