Toshiba DK 16, DK8 manual Local Terminal Operation, Remote Terminal Operation, Requirements, Set-up

REMOTE ADMINISTRATION AND MAINTENANCE PROCEDURES SECTION 100-816-600

MARCH 1993

continuing with Remote Administration and Maintenance installation.

5)If a terminal is to be utilized on-site, refer to Paragraph 5. For off-site programming refer to Paragraph 6.

4)Set the keyboard for “Caps Lock” on.

5)Set the parameters of the terminal (or modem) connected to the TTY to:

Word length: Seven bits

Stop bits: One

Parity: Even

5LOCAL TERMINAL OPERATION

5.00Requirements

5.01For DK16, the optional Expansion Unit must have a PIOU or PIOUS PCB installed to perform on-site Remote Administration from a local termi- nal. For DK8, a QSMU PCB is required. Paragraph 4 and Figure 5 provide installation details on local terminal installation.

5.02The local terminal for either the STRATA DK16 or the DK8 must have an EIA RS-232 inter- face, communicate in ASCII code at 300 or 1200 bps (1200 bps only for DK8), have a standard typewriter-type keyboard, and display data via a CRT display or printer. A personal computer (PC) capable of emulating the described terminal with a communications software package (such as PROCOMM) may also be used (Figure 5).

5.03Operating the PC or terminals, local or re- mote, is identical. The only difference is the physi- cal connection and the method used to establish initial communications.

5.10Set-up

5.11Refer to Figure 2 and verify that the local terminal is connected and set-up as follows:

1)Connect the RS-232 cable to the terminal connector and the PIOU(S) or QSMU TTY connector.

NOTE:

If a personal computer is being used, connect the cable to the serial “COM” port.

2)Set the PC or terminal baud rate to match the DK16 SW2 PIOU(S) setting (300 or 1200 bps) or the DK8 QSMU setting (1200 bps).

3)Set the terminal for “Full Duplex” operation.

5.20Local Operation

5.21Use the procedure below to establish com- munications between the local terminal and the PIOU(S) or the QSMU so that programming may be accomplished via the terminal.

NOTE:

Hereafter, whenever the term CR is used, it means the return or enter key, depending on the keyboard being used. SPACE means the space bar. An empty square indicates one of several characters will appear in that location (either on the terminal screen or in a printout).

1)Set-up the terminal as described in Paragraph 5.10.

2)Set the terminal to on-line.

3)Set “Caps Lock” on (upper case).

4)Press CR key.

•The system responds, and the terminal displays:

DK CONNECT > CODE

5)Type the four-digit security code, and press CR. (Default code = 0000.)

•The system responds, and the terminal displays:

OK

MODE

NOTE:

The security code can be entered any time the CODE prompt appears.

6) To continue, go to Paragraph 7.

6REMOTE TERMINAL OPERATION

6.00Requirements

6.01Terminal: For the STRATA DK8 or the STRATA DK16, the terminal must interface with an

-8-