Toshiba DK8 Enter the Program Mode, Enter Program Number, Exit Program, For DK16, Enter Program

	REMOTE ADMINISTRATION AND MAINTENANCE PROCEDURES
			SECTION 100-816-600
			MARCH 1993
	TABLE RM-D
	PROGRAM 90
	INITIALIZING PROGRAMS 00 ~ 97
STEP	ACTION		DISPLAY/PRINTOUT
1	Enter the Program Mode	>MODE PROG
	At the >MODE prompt enter P R O G CR.
2	Enter Program Number 90	P 90
	Press CR.	P90
3	To Initialize All Programs Enter 0 0 * 9 7	P90	00*97
	NOTE: Single programs can be initialized by entering a single
	program number plus #. Group numbers are separated by an *.
4	Enter button/LED number 0 1.	P90	00*97 01 N
5	Change 01 button/LED to “ON” by enteringY.	P90	00*97 01 N Y
6	Press SPACE.	P90	00*97 01 N Y
			02 N
7	Change LED 02 to “ON” by enteringY.	P90	00*97 01 N Y
			02 N Y
8	Press CR.	P90	00*97 01 N
	Initialization complete.		02 N Y
	NOTE: If program data is not entered correctly, then CR will	P90
	not respond. To retry, press DELETE CR.
9	Exit Program 90	P90	#
	Press # # CR.	P
10	For DK16, Enter Program 77	P77
	Press 7 7 CR.
11	Press 1 1 4.	P77	1 14 N
	then: Y CR.	P77	1 14 N Y
		P77
12	To Exit this Program:
	Press # # CR.

IMPORTANT NOTE:

For DK16 only: If all programs are initialized, the "IMDU enabled" has also been turned off in Program 77-1, LED 14. If using the IMDU for remote programming, go into Program 77-1and turn button/LED 14 on as shown in steps 9, 10, and 11. If this is not completed, remote programming must be reactivated locally from the programming digital or electronic telephone.

-15-