Toshiba DK 16, DK8 manual Table RM-BS STATION/CO Line Status Check

REMOTE ADMINISTRATION AND MAINTENANCE PROCEDURES

SECTION 100-816-600

MARCH 1993

TABLE RM-BS

STATION/CO LINE STATUS CHECK

STEP		ACTION	DISPLAY/PRINTOUT
1	Enter the Test Mode		>MODE TEST
	At the >MODE prompt, enter T E S T CR.
2	To Check Station Line Status		T SEKT XX IDLE ON-HOOK
	Enter	S E K T X X (X X = port number).	T
	Possible status: Idle on-hook, idle off-hook, busy on-hook,
	busy off-hook.
		IMPORTANT!
	To prevent service interference, station line status must be
	idle on-hook before initiating a test from that station.
3	To Check CO Line Status		T SCOYY – BUSY
	Enter S C O Y Y (Y Y = CO line number).		T
	Possible status: Idle, busy.
4	To Exit the Test Mode		T QUIT
	At the T prompt, enter Q U I T CR.		> MODE
		TABLE RM-BT
		GENERAL STATION ACCESS AND BUTTON ACTIVATION
STEP		ACTION	DISPLAY/PRINTOUT
1 Enter the Test Mode			>MODE TEST
	At the >MODE prompt, enter T E S T CR.		T
2 To Activate A Button			T TKXX KYY
	Enter T K X X K Y Y CR.		T

XX= Port number and YY = button number. NOTE: Button numbers begin at 01.

3	To Activate A Function Button					TTKXX F
	Enter T K X X F CR F = function button designator					T
		SPKR	S
		HOLD	H	F = S, H, C, M
		CONF	C
		MIC	M
4	To Access A CO Line (via CO Access Code) and Dial Out					TTKXX K01 AAA
	Enter T K X X K 0 1 A A A				CR.	T

AAA= 1, 2, or 3-digit CO line access code and = telephone number.

5 To Access A CO Line (via CO Line Button) and Dial Out			TTKXX KYY
Enter T K X X K Y Y		CR.	T
YY = CO line number.	Telephone Number

6To Exit the Test Mode

At T prompt, enter Q U I T CR.

-66-