Toshiba DK 16, DK8 manual DK16 Alarm Sensor Installation

INSTALLATION-PERIPHERALS

SECTION 100-816-207

MARCH 1993

•Program 35: LED 20 should be ON to assign auto attendant ports the “Busy Station Trans- fer” option. with this option the auto attendant will receive ring backtone when calling sta- tions designated with “Busy Station Ringing” (Program 35, LED 19 ON). This allows the auto attendant to transfer calls to busy sta- tions. Set LED 19 ON for answer position stations.

•Program 36: Set fixed call forward to VM/AA port per customer requirements.

•Program 37: Set the timer for the VM/AA ports to 22 seconds minimum to allow call forward no answer to work on VM transferred calls.

•Program 39: Set the Message Waiting Indi- cation, Fixed Call Forward, Redial, and Speed Dial Select buttons on the digital and elec- tronic telephones that will be used to commu- nicate with the VM/AA device.

NOTE:

Message Waiting (Msg) and Redial buttons are fixed buttons on digital telephones and it is not necessary to assign them in Program 39. Speed Dial is initialized as Button 20 on Digital telephones.

•Programs 81 ~ 89: Verify that the ringing assignments to the VM/AA devices are set per customer requirements.

•Programs 16, 40, 41, 45 ~ 48 and 50 ~ 56: Verify that outgoing CO line access is al- lowed on VM ports to allow the VM/AA beeper notification feature to operate.

7.25Voice Mail System Installation. Install the voice mail messaging system in accordance with the following steps (See Figure 7-22):

1)Ensure that the QSTU, KSTU, PSTU, or PESU PCB is installed in the system per Section 100-816-204(DK8) or Section 100-816-205(DK16).

2)Connect the voice mail messaging system to the selected QSTU, KSTU, PSTU, or PESU

standard telephone ports (refer to Wiring Dia- grams, Section 100-816-208, for QSTU, PSTU, KSTU, and PESU wiring/interconnecting de- tails).

3)Program the system for the required voice mail messaging features (refer to Paragraphs 7.13 and 7.22).

4)Ensure that the DK8 QRCU or DK16 K4RCU is installed, and (for DK16) verify that the CTU code in Program 03 is for KRCU-4 operation as required (this is not required for DK8 QRCU).

5)Perform additional voice mail messaging sys- tem programming as applicable (refer to cus- tomer-supplied installation/programming manuals).

NOTE:

Some voice mail devices may ring trip when called; in this case, set the ring voltage jumper to L (low position) on the QSTU, KSTU, PESU, or PSTU2 PCB connected to the voice mail device.

8 DK16 ALARM SENSOR INSTALLATION

8.00The PIOU or PIOUS PCB provides a circuit that can be set to detect a relay open or closed condition from a facility alarm system. When the sensor is activated, all electronic and digital tele- phones will sound an alarm signal. The electronic/ digital telephone alarm signal can be reset by any electronic or digital telephone with an alarm reset button (see Program 39).

8.01Alarm Sensor Options. Jumper plug P12 on the PIOU is used to set the alarm sensor to detect an open or closed condition from the facility alarm system. Set P12 as follows (refer to Figure 7-23):

• To detect a closed condition, set P12 to the N.O. position.

• To detect an open condition, set P12 to the N.C. position.

7-32