Toshiba DK 16, DK8 manual Enter the Message Mode, To Add Or Review a Calling Station Message

REMOTE ADMINISTRATION AND MAINTENANCE PROCEDURES

SECTION 100-816-600

MARCH 1993

TABLE RM-BO

MODE 95

REMOTE CALLING STATION MESSAGING (ADD/REVIEW/CHANGE)

STEP		ACTION		DISPLAY/PRINTOUT
1	Enter the Message Mode		>MODE MESG
	At the >MODE prompt, enter M E S G CR.
2	To Add Or Review a Calling Station Message		m 95
	Set the terminal keyboard to the lower case (cap lock off) and
	enter m 9 5.
	NOTE:
	Enter “m” anytime it is desired to start over in this procedure.
3	Enter X X X (XXX = station number where the message will be		m95 XXX
	set and stored).
4	Enter p	(p = page command and	m95 XXX p		[M]
	= 2-digit message memory location: 10 ~ 19 personal
	messages and 60 ~ 99 = system message).
	NOTES:
	1. To store system messages permanently, DKT or EKT XXX
	must be the station at port 00.
	2. After p	is entered, the previously stored message is
	displayed. If there is no stored message, nothing is displayed.
5	To Change Previous Message		m95 XXX p		[M+]
	Set the terminal keyboard to upper case and change message
	(alphanumeric, 32 characters max.).
6	To Set the Message on DKT or EKT XXX’s LCD		m95 XXX p		[M+] p
	Set the terminal keyboard to lower case and enter p m 0.		m 0
				Zero
7	To Exit the Message Mode		m 0
	At any time, enter m 0 q (lower case).		q
			> MODE

NOTES:

1.To cancel a message set via Mode 95, use Mode 97 procedure.

2.[M] represents the message entered.

3.DKT = digital telephone; EKT = electronic telephone.

-62-