Toshiba DK8, DK 16 manual To Change or Add a New Called Station Message, To Add the New Message M

		REMOTE ADMINISTRATION AND MAINTENANCE PROCEDURES
				SECTION 100-816-600
					MARCH 1993
		TABLE RM-BR
		MODE 96
		REMOTE CALLED STATION MESSAGING (ADD/CHANGE)
STEP		ACTION		DISPLAY/PRINTOUT
1	Enter the Message Mode		>MODE MESG
	At the >MODE prompt, enter M E S G CR.
2	To Change or Add a New Called Station Message		m 96
	Set the terminal keyboard to the lower case (cap lock off) and
	enter m 9 6.
	NOTE:
	Enter “m” (lower case) anytime it is desired to start over
	in this procedure.
3	Enter X X X (XXX = destination station number or destination		m96 XXX
	station group number – 30 = all DKTs/EKTs, 31 ~ 34 per system,
	Program 31).
4	Enter p Y Y Y (p = page command and YYY = originating		m96 XXX p YYY
	station number).
5	Enter p	(p = page command and	m96 XXX p YYY p
	= 2-digit message memory location: 10 ~ 19 personal
	messages and 60 ~ 99 = system messages).
6	To Add the New Message [M]		m96 XXX p YYY p		[M]
	Set the terminal keyboard to upper case and enter message
	as required (alphanumeric, 32 characters max.). New message
	displays as it is entered.
7	To Set the Message		m96 XXX p YYY p		[M] p
	Set the terminal keyboard to lower case and enter p m 0.		m 0
	Destination station: Msg LED flashes, “CALL YYYM” is			Zero
	displayed on LCD.
	Origination station: “SENT XXXM” is displayed on LCD.
8	To Exit the Message Mode		m 0
	At any time, enter m 0 p (lower case).		q
			>MODE

NOTES:

1.[M] represents the message entered.

2.DKT = digital telephone; EKT = electronic telephone.

-65-