Toshiba DK 16 To Add Or Review a Called Station Message, To Change the Message M+, To Set Message

REMOTE ADMINISTRATION AND MAINTENANCE PROCEDURES

SECTION 100-816-600

MARCH 1993

TABLE RM-BQ

MODE 94

REMOTE CALLED STATION MESSAGING (ADD/REVIEW/CHANGE)

STEP		ACTION		DISPLAY/PRINTOUT
1	Enter the Message Mode		>MODE MESG
	At the >MODE prompt, enter M E S G CR.
2	To Add Or Review a Called Station Message		m 94
	Set the terminal keyboard to the lower case (cap lock off) and
	enter m 9 4.
3	Enter X X X (XXX = Destination station number or destination		m94	XXX
	group number [30 = all stations, 31-34 per system, Program 31]).
4	Enter p Y Y Y (p = page command [lower case] and		m94	XXX p YYY
	Y Y Y = originating station number).
5	Enter p	(p = page command [lower case] and	m94	XXX p YYY p	[M]
	= 2-digit message memory location: 10 ~ 19 personal
	messages and 60 ~ 99 = system messages).
	After p	is entered, the previously stored message (M) is
	displayed. (If there is no stored message, nothing is displayed.)
6	To Change the Message (M+)		m94	XXX p YYY p	[M+]
	Set the terminal keyboard to upper case and change message
	as required (alphanumeric, 32 characters max. for total message).
7	To Set Message		m94	XXX p YYY p	[M+] p
	Set the terminal keyboard to lower case and enter p m 0.		m 0
	Destination station: Msg LED flashes, “CALL YYYM” is			Zero
	displayed.
	Origination station: “SENT XXXM” is displayed.
8	To Exit the Message Mode		m 0
	At any time, enter m 0 q (lower case).		q
			>MODE

NOTES:

1.Press m at any time to start over.

2.[M] represents the message entered.

-64-