Toshiba DK8, DK 16 manual M97 XXX p, To Add a Message, To Set the Message on the DKT/EKT LCD

		REMOTE ADMINISTRATION AND MAINTENANCE PROCEDURES
						SECTION 100-816-600
						MARCH 1993
		TABLE RM-BP
		MODE 97
		REMOTE CALLING STATION MESSAGING (ADD/CHANGE)
STEP		ACTION			DISPLAY/PRINTOUT
1	Enter the Message Mode		>MODE MESG
	At the >MODE prompt, enter M E S G CR.
2	To Add a Message (or change a previously stored message)		m 97
	Set the terminal keyboard to lower case (caps lock off) and
	enter m 9 7.
	NOTE:
	Enter “m” at anytime it is desired to start over in this procedure.
3	Enter X X X (XXX = station number for which the message will		m97 XXX
	be set and stored).
4	Enter: p	(p = page command and	m97 XXX p
	= 2-digit message memory location: 10 ~ 19 personal
	messages and 60 ~ 99 = system messages).
	NOTE:
	To store system message change permanently, DKT or EKT XXX
	must be station assigned to port 00.
5	To Add a Message		m97 XXX p			[M]
	Set the terminal keyboard to upper case and enter message
	(alphanumeric, 32 characters max.). New message displays as
	it is entered.
6	To Set the Message on the DKT/EKT LCD		m97 XXX p			[M] p
	Set the terminal keyboard to lower case and enter p m 0.		m	0	Zero
7	To Exit the Message Mode		m 0
	At any time, enter m 0 q (lower case).		q
			>MODE

NOTES:

1.To cancel a message set via Mode 95, use Mode 97 with any message number in step 4 and skip step 5.

2.[M] represents the message entered.

3.DKT = digital telephone; EKT = electronic telephone.

-63-