Toshiba DK8, DK 16 manual Table RM-BW Speed Dial Mode CHANGE/REVIEW

REMOTE ADMINISTRATION AND MAINTENANCE PROCEDURES

SECTION 100-816-600

MARCH 1993

TABLE RM-BW

SPEED DIAL MODE (CHANGE/REVIEW)

STEP						ACTION			DISPLAY/PRINTOUT
1	Enter the Speed Dial Mode						>MODE REPT
	At the >MODE prompt, enter R E P T CR.
2	Enter the station port number for which the speed						R
	dial number will be programmed								Station Port Number
	Press
				(00 ~ 19)
		NOTE: If programming system speed dial, enter
		port number 0 0.
3	Enter Speed Dial Memory Location to be Programmed						R			N
	A)	Press				(current memory will display)
						10 ~ 49 Station		Memory			Nothing in
						60 ~ 99 System		location			memory
	B)	Press SPACE to review each memory location or go to Step 4.
4	1) To enter speed dial number (20 digits max)						R			N
			20-digit number							. . . . . . . . . .
	Press		. . . . . . . . . .
	2) To enter chain dial number								New speed dial number
						17-digit number
	Press A		. . . . . . . . . . . .
					System speed dial location (90 ~ 99)
	(Refer to Digital or Electronic Telephone User Guide for
	information regarding chain dialing.)
	Special Entries: F=Flash; P=1.5 or 3-sec Pause (Prog. 12);
						L=10-sec Pause; N=Clear Memory.
	Special code entry: I = Intercom
						H = Hold
						C = Conference
5	To store data, press CR						R
	NOTE: If program entry is not correct, CR will not
	respond. To try again, press DELETE CR at the same time.
6	To Exit the Speed Dial Mode						>MODE
	Press Q U I T CR.

-69-