Invacare L-4, L-3 Service Indicator Error Codes,  For the following table, refer to .1 on

14 TROUBLESHOOTING

14.2Service Indicator Error Codes

For the following table, refer to FIGURE 6.1 on page 25.

FLASH	DESCRIPTION	MEANING
1	Battery Low	The batteries are running low.
		• Recharge the batteries.
2	Low Battery Fault	The batteries have run out of charge.
		• Recharge the batteries.
3	High Battery Fault	Battery voltage is too high. This may occur if overcharged &/or traveling down a long slope.
		• If traveling down a slope, reduce your speed to minimize the amount of regenerative charging.
		• Check the battery and associated connections and wiring.
4	Current Limit Time-out	The motor has been exceeding its maximum current rating for too long. This may be due to a faulty motor.
		• Check the motor and associated connections and wiring.
		• Turn the controller off, leave for a few minutes and turn back on again.
5	Park Brake Fault	Either a park brake release switch is active or the park brake is faulty.
		• Check the park brake and associated connections and wiring.
		• Ensure any associated switches are in their correct positions.
6	Throttle OONAPU	The Throttle is out of neutral when turning the controller on.
		• Ensure the throttle is in neutral when turning the controller on.
		• The Throttle may require re-calibration.
7	Speed Pot Fault	The throttle, speed limit pot, SRW or their associated wiring may be faulty.
		• Check the throttle and speed pot and associated connections and wiring.
8	Motor Voltage Fault	The motor or its associated wiring is faulty.
		• Check the motor and associated connections and wiring.
9	Other error	The controller may have an internal fault.
		• Check all connections & wiring.
10	Push/Rollaway Fault	The scooter has exceeded the Push or Rollaway speed limits.
		• Turn the controller off and then on again.

Invacare® Lynx™ L-3& Invacare® Lynx™ L-4 Scooters 54 Part No. 1143205