10 BATTERIES
10.4 Charging the Batteries
WARNING
NEVER attempt to recharge the batteries by attaching cables directly to the battery terminals or clamps. DO NOT attempt to recharge the batteries and operate the powered scooter at the same time.
Only use the provided charger with this product.
If the circuit breaker trips repeatedly, IMMEDIATELY unplug charger and contact dealer or a qualified technician.
CAUTION
New batteries MUST be fully charged prior to initial use of the powered scooter. DO NOT sit in the scooter while recharging the batteries.
ALWAYS charge new batteries before initial use or battery life will be reduced.
As a general rule, you should recharge your batteries as frequently as possible to assure the longest possible life and to minimize required charging time. Plan to recharge them when you do not anticipate using the powered scooter.
The powered scooter is designed with an electrical lockout to prevent it from being driven while the charger is plugged into an outlet.
Always charge the batteries completely until the battery charger light turns GREEN.
The range per battery charge using recommended batteries should be approximately five to nine hours of typical operation. Extensive use on inclines may substantially reduce per charge mileage.
1.Turn the key to the Off position.
2.If desired, remove the battery box from the scooter. Refer to Removing/Installing the Battery Box on page 38.
3.Ensure the brake release lever is engaged. Refer to Engaging/Disengaging the Brake Release Lever on page 22.
4.Move the battery charger port cap (located on the left side of the battery box) to one side.
5.Remove the battery charger cable from the storage compartment on the front of the battery box.
6.Plug one end of the battery charger cable into the battery charger port located on the battery box.
7.Plug the other end of the battery charger cable into
Invacare® Lynx™ | 42 | Part No. 1143205 |
