12 ACCESSORIES

12.4 Installing/Removing/Using the Walker Holder

￿

WARNING

After ANY adjustments, repair or service and before use, make sure that all attaching hardware is tightened securely.

The installation of the walker holder onto the back of the scooter seat significantly increases the length of the scooter. When turning the scooter or swiveling the scooter seat, it is important to take note of this increased length - otherwise, injury and/or damage to the surrounding property may result.

For this procedure, refer to FIGURE 12.4.

Installing/Removing the Walker Holder

Reverse this procedure to remove the walker holder.

1.If necessary, loosen but DO NOT remove the mounting knob.

2.Install the walker holder into the accessory tube.

3.Thread the mounting knob into the welded nut on the accessory tube. Securely tighten.

Using the Walker Holder

1.Fold walker. Refer to walker instructions.

Walkerholder. MUST be folded before using walker

2.Hang folded walker on walker holder hooks.

3.Secure walker with hook and loop straps.

Walker Holder

Hook

Accessory

Tube

 

 

Mounting

Hook and

Knob

 

Loop Strap

Insert Into

 

 

Accessory Tube

FIGURE 12.4 Installing/Removing the Walker Holder

Part No. 1143205

49

Invacare® Lynx™ L-3& Invacare® Lynx™ L-4 Scooters

Page 49
Image 49
Invacare L-3, L-4 user manual Installing/Removing/Using the Walker Holder, Installing/Removing the Walker Holder