Step 5 — Test the equipment.
After the ConnecT/R is installed, test the tel- phone device and SPIRIT Telephone as follows.
1.To test for dial tone, pick up the receiver (or its equivalent) of the telephone device and listen. If there is no dial tone
–Check whether the attached SPIRIT Telephone (if there is one) is in use and whether the MODE setting is 2 or 4.
–Check the wiring and power connections.
–Be sure that the port on the controller is administered for Automatic Line Selec- tion.
2.To test for ringing, call the intercom number from another telephone. If the telephone device doesn't ring:
–Check that the ringer is turned on and that its volume is turned up.
–Make sure the attached SPIRIT Tele- phone (if there is one) is not in use.
–Check the wiring and power connections.
–Be sure the port on the controller is administered to ring for lines that are available.
You can check the SPIRIT Telephone in the same way.
If you have any problems, see the Troubleshoot- ing section of this manual for more information.
13