Installation

Box Contents

Before installing your phone, check the shipping carton to be sure you have the following:

Base Unit	Quick Installation Guide
Long Telephone Line Cord	DC Adaptor with Cord
Handset with Rechargeable Battery	Owner's Manual

Notes:

a. Keep the shipping carton and packaging, in case you need to transport your phone.

b.If there is visible damage, do not use this equipment. Contact your shipping agent or return the telephone to the place of purchase.

Installation (Cont.)

Table/Desk Installation

A.Plug one end of the long telephone line cord into the back of the unit and connect the other end to a modular wall jack. Press until locking lever clicks (Fig. 1).

B.Connect the AM look antenna into the back the unit (Fig.1). Place it on the desk or mount it on the wall (Fig.2).

C.Connect the DC Adaptor into the back

of the unit. Plug the other end into a

Handset Battery Charging

The battery pack in the handset must be fully charged for about 10-14 hours before using the telephone. The Radio may be used prior to the handset being fully charged. An extension telephone will be required until the handset is charged.

HANDS ET IN

THE BAS E

FACE DOWN

Preliminary Preparation Telephone Line Installation

1.Never install telephone jack during a lightning storm.

2.Never install telephone jack in wet locations unless the jack is specifically designed for wet locations.

3.Never touch uninsulated telephone wires or terminals unless the telephone line has been disconnected at the network interface.

4.Use caution when installing or modifying telephone lines.

Modular Outlet

The GH3060 Cordless Telephone operates from a standard 110/120 volt outlet. The handset is powered by a rechargeable battery pack. Batteries are charged automatically when the handset is placed in the cradle of the base unit.

Battery Backup

One 9 volt battery (not included) is required to maintain clock and alarm time, and memory settings during a power failure. If there is a power failure and the battery is not installed, clock and alarm time, and memory settings will be lost.

1.Make sure DC adaptor is unplugged from electrical outlet.

2.On the bottom of the base, press on the tab (toward the battery compartment door), and then lift the door away from the unit.

3.Install one 9 volt battery.

4.Replace battery compartment door.

5.Install a replacement battery once a year to ensure proper operation of the power failure protection feature. BATTERY LOW icon will turn on until a 9 Volt battery is installed. Your unit is fully functional. Battery is needed for power failure backup ONLY.

standard 110/120 volt outlet (Fig. 1).

D. Place the handset into the base. The handset will beep .

NOTE: BATTERY PACK MUST BE CHARGED FOR 10-14 HOURS BEFORE INITIAL OPERATION.

Fig. 1
DC adaptor
Line cord	AM antenna
Fig.2

CHARGE		ALARM	SPEAKER
SET	SNOOZE	1	2

After connecting the unit to DC power, leave the handset in the base cradle for ten to fourteen hours before using it for the first time. The CHARGE LED on the base will be lit when the handset is in the cradle. Later, it will take less time for the battery to recharge.

Note:

a. When the battery gets low, there will be a low-battery beep from the handset every 10 seconds . The handset will display "BATTERY LOW" on the bottom line.

b. If the battery becomes low while you are using, you will be disconnected after about 1 minute. Terminate the call quickly and put the handset in the base to recharge the battery.

C. The battery will hold its charge for several days out of the cradle, depending on use.