Shiro SK9151 user manual Technical details, Declaration of conformity

Check the Batteries Level symbol on the display. If it is low, recharge the batteries.

The Caller Display feature isn’t working.

You need to subscribe to the Caller Display feature from your service provider.

The caller may have withheld their number, or they may be calling from a network that does not transmit the Caller ID (for example, it may be an international call).

The handset’s batteries are running low within an hour or two.

Before you used the handset for the first time, you should have left it on the base unit for up to 15 hours to charge the batteries fully. You may need to replace the batteries.

I cannot transfer a call.

Make sure the other handset is within range of the base unit, and is not busy on a call. Make sure you are keying in the correct number for the other handset.

No display on LCD screen.

Make sure the batteries have power.

I cannot register handset to base

Make sure the number of handset registered to base is less than 3.

Check that the base unit is not near other electrical equipment, such as TV or computer

Technical details

Full DECT GAP Compatible system

Standard	Digital Enhanced Cordless Telecommunications (DECT)
Frequency range	1.88 to 1.9 GHz
Channel bandwidth	1.728 MHz
Modulation	GMSK
Operating range	Up to 300 m outdoors; Up to 50 m indoors
Operating time	Standby time: 100 hours, Talking time: 8 hours
Temperature range	Operating 00C to 400C, Storage -200C to 600C
Electrical power	Handset- One 1.2 x 2 V 750 mAH Ni-MH, Rechargeable battery cell
Base unit	Input 230 V AC, 50 Hz;
	Output AC 7.5V, 350 mA.
Headset Earpiece	2.5mm jack
PABX compatibility	Pause length: 3 seconds.
	Signaling type: DTMF (Dual-Tone Multifrequency)
	Pulse dialing

Declaration of conformity

The SK9151 complies with the essential protective requirements and objectives of:

•EC R& TTE Directive 1999/5/EC

•EC Low Voltage Directive 73/23/EEC

•EC EMC Directive 89/336/EEC

17