Southwestern Bell FM2572 owner manual General Information Telephone Installation

General Information

Telephone Installation

UNPACKING

This package contains:

•FM2572 Telephone with Caller ID/Call Waiting and Digital Answering System

•One (1) AC Adaptor 120V AC

•Owner's manual

•One (1) Desk Mount Bracket

•One (1) Fully Modular Coil Cord

•One (1) Long Fully Modular Telephone Line Cord (Long Straight Cord)

•One (1) Short Fully Modular Telephone Line Cord (Short Straight Cord)

•One (1) Quick Reference Guide

•Warranty Card (Part Of Owner's Manual)

•Remote Access Card

If anything is missing or damaged, contact the place of purchase. Keep the packaging to transport the telephone.

Helpful Tips From Customer Service

Battery Installation

1.Insert a ball point pen into the hole located in the battery compartment door (on the bottom of the base). This will loosen the door, and you should lift the battery compartment door.

2.Install one 9V Alkaline battery. One 9 volt battery (not included) is required to maintain your personalized greeting and recorded messages during a power failure. If there is a power failure and the battery is not installed, both your personalized greeting and recorded messages will be lost. NOTE: You must install 9 volt battery

in order for the Caller ID and Telephone operation to function properly.

AM

Figure B

Choose Your Location

Before making any connections, install the FM2572 near an AC power outlet and a telephone wall jack (RJ11C).

Desk or Table Installation

1.Connect the COIL CORD into the jack on the bottom of the base (Fig. C).

1.	You must subscribe to Caller ID and Call Waiting service from your local
telephone company for your FM2572 to operate.
2.	Remove the "peel off label" covering the FM2572's display.
3.	Plug one end of the telephone line cord into the TELEPHONE LINE jack on the
FM2572 and the other end into the modular outlet in your telephone wall jack.

Battery	Figure C
	2. Plug one end of the telephone line
9V
	cord into the TELEPHONE JACK located
	on the back of the FM2572, and the other
	end into the modular outlet in your
	Figure A
	telephone wall jack (Fig. D).

4.	Plug the AC Power Adapter into the FM2572 before connecting it to the wall outlet.
5.	Make sure you can read the display clearly. Adjust the display contrast by pressing
and holding the CALL BACK and ERASE buttons at the same time for 2 seconds.
Rotate the "REVIEW" knob to select the contrast. Press ERASE to confirm the contrast.

Installation

CAUTION

1.Never install telephone wiring during a lightning storm.

2.Never install telephone jacks in wet locations unless the jack is specifically designed for wet locations.

3.Never touch uninsulated telephone wires or terminals unless the incoming telephone line has been disconnected at the network interface.

4.Use caution when installing or modifying telephone lines.

Note: Refer to "FCC Requirements" section on page 28 before connection to telephone line.

3.Replace battery compartment door and snap into place.

Note: After installing a 9V battery, system displays "SET LANGUAGE s t". Your FM2572 enters setting mode. (See Setting Up Your FM2572 section for details.)

Replace a new 9V alkaline battery when the Battery Low Indicator (BATTERY LOW ICON) appears on the LCD display. The battery level is indicated by the presence of the battery indicator during normal operation. If the 9 Volt battery is low or has been installed incorrectly, the battery low indicator will appear on the LCD display. (Fig. B)

Figure D

3.Connect the AC adaptor into the AC ADAPTOR JACK on the back of the base and into the AC wall power outlet. Do not attach (staple, etc.) the power supply cord to the building wall (Fig. E).

Figure E

AC

ADAPTER

The Message Counter will then countdown from 9 to 0. The unit is checking its memory, and you should not press any buttons.

8 9