Sipura Technology 3000 manual Initial SPA configuration

Page 3
http://<the IP address you wrote down>/admin/advanced

Device Quickstart Guide

3. Initial SPA configuration

Initial configuration is completed by use of the connected telephone set and the SPA’s built-in IVR (Interactive Voice Response) service. Whilst it is possible to configure the SPA with only the telephone set, it is far easier to understand and modify the various parameters if programming is completed using the SPA’s built-in web interface. Before you can use your PC and browser however, you must complete the basic network configuration tasks with the telephone set.

To bring up the IVR service, lift the handset and dial **** (ignore any tones you may hear whilst dialling the four “stars” – you will eventually hear “Sipura configuration menu .. “

Check whether DHCP is enabled by entering 100#

If you use DHCP, enter code 110#, the IVR should announce the IP address, write it down and skip to step 9 bellow.

Note: To enable/disable DHCP, enter 101#, then when prompted enter 1 to enable or 0 to disable.

If DHCP is enabled, check whether your SPA has successfully received an IP address thus, according to step 2.

If DHCP allocation was unavailable, you will need to set the IP address manually.

Firstly, switch off DHCP by entering 101#, then 0

Use command 111# to set IP address, enter numbers from the telephone keypad – use the * key for the decimal point. (e.g. 10*10*60*134)

Check Subnet Mask using 120#. If you need to change the setting, use 121# to set Subnet Mask. Using numbers and * as above to enter the desired value (e.g. 255*255*255*0).

Check the IP address of your Internet gateway using 130#. If you need to change/set this address, use

131# - once more using numbers and * to enter the desired value (e.g. 10*10.*60*254)

Review the IP address setting using 110# - write it down.

You may now connect to the SPA from your PC browser – the PC must be connected to the same network as the SPA. In your browser address

window typeand press return on your PC keyboard.

© Phoneserve. All Rights Reserved Worldwide.

info@phoneserve.com

3

 

 

Image 3
Contents Device Details ContentsBefore you begin Cabling the SPA3000SPA3000 Cabling Initial SPA configuration IVR Code table Proxy adp1.winnerip.com Interface ConfigurationMaking Phone Calls through the Pstn line Pstn Line TabUser ID Phoneserve Account Number 18 digits How can you protect your Pstn line with a PIN? Contact & FeedbackManager