GETTING STARTED
Connect Telephone Line Cord
Plug one end of the telephone cord into a wall jack and the other end into the back of the base unit.
Check for a dial tone. After the battery pack is charged, put on the headset and flip the microphone down into the ON position. You should hear dial tone.
If not, see IN CASE OF DIFFICULTY.
Fill in the telephone number card on the remote charging stand.
DIALING | ||
MEMORY | • | |
| • |
|
• |
| • |
• |
| • |
• |
| • |
• |
| • |
| • | • |
| • | • |
| • | • |
| • | • |
|
| • |
|
| • |
CAUTION :
1.Never install telephone wiring during a lightning storm.
2.Never install telephone jacks in wet locations unless the jack is specifically designed for wet locations.
3.Never touch uninsulated telephone wires or terminals unless the telephone line has been disconnected at the network interface.
4.Use caution when installing or modifying telephone lines.
13