Telephone base and charger installation

Install the telephone base and charger as shown below.

Telephone base power adapter

Electrical outlet not controlled by a

wall switch

Telephone wall jack

If you have DSL	Charger adapter
high speed Internet
service, a DSL filter
(not included) is
required.

Electrical outlet not controlled by a wall switch

Telephone line cord

Telephone base

Charger

•Use only the power adapter and battery supplied with this product. To order a replacement, visit our website at www.vtechphones.com or call 1 (800) 595-9511. In Canada, go to www.vtechcanada.com or call 1 (800) 267-7377.

•The power adapter is intended to be correctly oriented in a vertical or floor mount position. The prongs are not designed to hold the plug in place if it is plugged into a ceiling, under-the-table or cabinet outlet.

Battery installation

Install the battery as shown below.

1Plug the battery connector securely into the socket.

3Slide the battery compartment cover towards the center of the handset until it clicks into place.

2Place the battery with the label THIS SIDE UP facing up and the wires inside the battery compartment.

4Place the handset in the telephone base or charger to charge.

CHARGE light

remains on when charging.

If the handset will not be used for a long time, disconnect and remove the battery to prevent possible leakage.

Battery charging

Once you have installed the battery, the screen indicates the battery status (see the table on the next page).

•For best performance, keep the handset in the telephone base or charger

when not in use.

•The battery is fully charged after 10 hours of continuous charging.

•If you place the handset in the telephone base or the charger without plugging in the battery, the screen displays NO BATTERY.