| Battery indicators | Battery status | Action | |||
|
|
|
|
|
|
|
| The screen is blank, | Battery has no charge | Charge without | |||
| or shows PLACE IN | or very little charge. The | interruption (at least | |||
| CHARGER and |
| flashes. | handset cannot | 30 minutes). | |
|
|
|
|
| be used. |
|
|
|
|
|
|
|
|
| The screen shows | Battery has enough | Charge without | |||
| LOW BATTERY and | charge to be used for | interruption (at least | |||
|
| flashes. | a short time. | 30 minutes). | ||
|
|
|
|
|
|
|
| The screen shows | Battery is charged. | To keep the battery | |||
| HANDSET X. |
| charged, place it in | |||
|
|
|
|
|
| the telephone base or |
|
|
|
|
|
| charger when not in use. |
|
|
|
|
|
|
|
Tabletop to wall mount installation
The telephone comes ready for tabletop use. Follow the steps below to mount your telephone on a wall.
1Plug one end of the telephone line cord into the TEL LINE jack at the bottom of the telephone base and the base power adapter into the
POWER jack.
2Position the telephone base against the wall mount bracket as shown. Insert the extended tabs marked B on the wall mount bracket into the slots marked B on the back of the telephone base.
3Route the telephone line cord through the hole on the wall mount bracket and plug it into the telephone wall jack. Route the power cord out of the telephone base and plug it into an electrical outlet not controlled by a wall switch.
4Align the holes on the bracket with the standard wall plate and slide the bracket down until it locks securely. Bundle the telephone line cord and power adapter cord neatly with
twist ties.
Telephone base overview
IN USE light
On when the handset is in use.
Flashes quickly when there is an incoming call.
Flashes slowly when another telephone sharing the same line is in use.
/FIND HANDSET
Press once and then release to page all system handsets.