BASE UNIT FEATURES
BASE UNIT FUNCTION KEYS
POWER lndicator
Glows when the power supply is plugged in and power is applied to the Base Unit.
HS
Glows when the Handset has been activated.
CHARGING lndicator
Glows when the Handset is placed in the Base Unit cradle. If there is no battery pack in the Handset, the CHARGING LED will flash slowly.
SPARE BATT lndicator
Glows when an optional battery pack is installed in the Base Unit charger.
HOLD lndicator
Glows when an active call is placed on
HOLD.
MUTE lndicator
Glows when the Base Unit MUTE key is pressed during an active call.
INT.COM lndicator
Glows when the Base Unit is in INTERCOM mode with the Handset.
SPEAKERPHONE (SP PHONE) lndicator
Glows when the Base Unit Speakerphone is active.
Flashes slowly to indicate that an extension phone is in use.
Flashes in cadence with the incoming ring.
Speakerphone (SP PHONE) Key Press this key to either initiate or answer a call from the Base Unit Speaker. Press it again to terminate your call.
Volume (VOL) Key
Press the appropriate key to raise or lower the Speakerphonevolume level. Holdingdown the key will continuously raise or lower the volume. There are a total of 8 volume levels.
Base Ringer ONlOFF Switch Locatedon the bottomof the Base Unit, this switch controls the Base Unit ringer. It has no affect on the Handset ringer.
TONEIPULSE Switch
Locatedon the bottomof the Base Unit, set this switch consistent with your local phone system. In most cases, the appropriate setting is TONE(TT).
Memory (MEM) Key
Pressthis key to enter Memory (Speed) Dialing Mode.
Quick Memory (Q.MEM) Key Press this key to dial the contents of memory location #00. The Base speakerphone can be either ON or OFF to use this feature.
REDIAL Key
Press this key to redial the last number you dialed from the Base Unit. This feature is independent of the Handset redial feature.
HOLD Key
Press this key to place your Speakerphone call on hold. Press
either @ m ) o r @@to-return to the call.
With a Speakerphone call on HOLD, picking up an extension phone, or activating the VT 1940 Handset will turn the Speakerphone OFF.
FLASH Key
During a Speakerphonecall, press this key to flash the line. The feature is commonly used in conjunction with Call Waiting.
MUTE Key
Press this key to mute the Base Unit microphone durin a Speakerphone
call. PressKEY( again to return to the 2-way conversation.
Intercom (1NT.COM) Key
Press this key to page the Handset. The Handset will ring 5 times. The Handset user can respond by pressing
7INT COM .The Handset and Base Unit have now entered
Press ( M Ito terminate INTER- COM mode.
This feature is also useful as a Handset locator in the event it is misplaced.