INTRODUCTION
FCC and IC Regulations
Parts Check List | To purchase replacement battery | ||
1. | Handset | packs, call VTECH Communications | |
2. | Base Unit | at | In Canada, call |
3. | Wall mounting bracket | VTECH Electronics | at |
4. | AC power adapter | 7377. |
|
5.Belt clip
6.Battery pack
7.Telephone line cord
This equipment complieswith Parts 15 and 68 of the FederalCommunications Commission (FCC) rules for the United States. It also complies with regula- tions RSS210 and
(1)this device may not cause interfer- ence, and (2) this device must accept any interference, including interfer- ence that may cause undesiredopera- tion of the device.
Alabel is located on the underside of the base unit containing either the FCC registration number and Ringer Equiva- lence Number (REN) or the lndustry Canda (IC) registration number and Load Number. You must, upon re- quest, prov.ide this information to your local telephone company.
This equipment is compatible with inductively coupled hearing aids.
FCC Part 15
Warning: Changes or modificationsto this unit not expressly approved by the party responsible for compliance's could void the user's authority to operate the equipment.
The equipment has been tested and found to comply with part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment gener- ates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful inter- ference to radio communications. However, there is no guarantee that interference will not occur in a particu- lar installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to
HANDSET
WALL MOUNTING
BRACKET
BASE UNIT
Should you experiencetroublewith this telephone equipment, please contact:
VTECH COMMUNICATIONS
SERVICE DEPT. at
try and correct the interferenceby one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between
the equipment and receiver.
- Connect the equipment into an
n
BELT CLIP
AC POWER ADAPTER
3B6-
For repairlwarranty information. The telephone company may ask you to disconnect this equipment from the line network until the problem has been corrected.
outlet or on a circuit different from that to which the receiver is con- nected.
- Consult the dealer or an experi- enced radio/TV technician for help.
TELEPHONE LINE CORD | BATERY PACK |
|