VTech VT1940 manual Storing Numbers Using Redial, Changing Stored Numbers, Press Epause

Page 15

STORING NUMBERS USING REDIAL

To store the last number dialed into a permanent memory location, do the following, from the handset:

The handset should be OFF. Press (m)The.PHONE LED will flash quickly to indicate the unit is in program mode.

STORING NUMBERS

USING REDIAL

THE HANDSET SHOUlLD BE

OFF

PRESS a

THE PHONE LED WlLl.FLASI

ENTER MEMORY

LOCATION (00-20)

Enter the memory location (00..20) you wish to store the number in. press E~).

Press MEM to store the number and exit program mode. The unit will emit a happy tone (a series of short beeps) to confirm successful programming.

If programming is unsuccessful the unit will generate an error tone.

DIALING FROM MEMORY

)to

press ( m e or 6

get dial tone. press m.

Enter a 2 digit location number

(00..20)

The number stored in that location

CHANGING STORED NUMBERS

To change or replacea stored number, simply store a new number in the desired memory locationfollowing the instructions listed in STORING

MEMORY DIAL NUMBERS.

DELETING STORED NUMBERS

To delete a stored numberfrom memory do the followin&from the handset:

Press to enter program mode.

Enter the memory location (00..20). Press @to exit program mode.

If your phone is connected to a PBX you can store the PBX access number and a pause beforethe phone number. For example, to store 9-PAUSE-555- 1234 in memory location 08, do the

following: - Press fFKZ4

Press 08 (memory location) Press 9

Press (E)(pause)

Dial 5551234

Press

PRESS a PRESS a

will be automatically dialed.

riMEMORY DIALING

PRESS@

@ @ @ PRESS-

@a ENTER MEMORY

@ @ LOCATION (00-20)

0 - 0

G3 - E3

DELETING STORE

@@II ENTER MEMORY a LOCATION (00-20)

@@

Storednumbersare retainedin memory even if the base loses its power or the handset battery is removed.

STORING SPECIAL CODES

To insert a ause in a phone number, press (HOLD)at the appropriate point when entering the number. This inserts

a 2 second&ause. For longer pauses,

press two or moretimes. Each press makes the pause 2 seconds longer, and is treated as a stored digit.

Image 15
Contents 1vrmj Memoryspeed Dialing Face up or Face down Handset Charging Special Features 900 MHz OperationIntroduction New standard in cordless telephone technologyVtech Communications FCC and IC RegulationsFCC and IC Regulations Read and understand all instruc- tions Important Safety InstructionsTo Charge The Battery Pack Replacing the Battery PackIts ImpossibleTo Overcharge The Battery Pack To Replace The Handset Battery Pack Follow The Steps BelowAcaution Replacing the Battery Pack Getting StartedFill in the telephone number card on the base unit Wall MountingBase Unit Layout Handset LayoutHold Base Unit Features Base Unit Function KeysExtension in USE ToneAdvanced Functions Basic OperationChecking the Ringer Type Programming the RingersChanging Ringer Types Turning OFF the RingersPress Epause Storing Numbers Using RedialChanging Stored Numbers Memory Dial Numbers Deleting Stored NumbersAdditional Operating Tips Maintenance Case of Difficulty Warranty Statement Frequencycontrol WeightPower Requirements Specifications are Typical and MAY Change Without NO- Tice