VTech VT 2428 manual Case of Difficulty, If the phone doesn’t work at all, check these items first

Page 18

IN CASE OF DIFFICULTY

If you have difficulty operating this phone, try the suggestions below.

For Customer Service, call 1-800-595-9511. Please retain your receipt as your proof of purchase

If the phone doesn’t work at all, check these items first:

•Make sure the AC adapter is plugged into an outlet not controlled by a wall switch.

•Make sure the telephone line cord is plugged firmly into the base unit and the modular jack.

•Make sure the base antenna is fully upright.

•If the handset does not beep when you press PHONE, the battery might need charging.

•Make sure the battery pack is installed correctly.

•If you have dial pulse (rotary) service on your phone line, make sure the dial mode is set to dial pulse (see INSTALLATION).

•Microwave appliances may cause interference with this phone. If you experience interference, move away from the microwave

If the above suggestions don’t solve the problem, try re-initializing the handset and base:

1Disconnect the power to the base.

2Remove the handset battery pack.

3Wait a few minutes.

4Connect the power to the base.

5Insert the handset battery pack.

6Put the handset in the base to re-initialize.

If you hear a two-beep signal when you try to use the handset:

•You might be out of range. Move closer to the base and try again.

•If moving closer to the base doesn’t help, try following the directions above for re-initializing the handset and base.

If the phone does not ring when you receive a call:

•Make sure the handset ringer is on.

•Make sure the telephone line cord is connected firmly to the base and the telephone jack.

•Make sure the AC adapter is plugged firmly into an outlet not controlled by a wall switch.

•You might be too far from the base; move closer.

•You might have too many extension phones on your telephone line to allow all of them to ring. Try unplugging some of them.

If you hear noise or interference when using the phone:

•Make sure the base antenna is fully upright.

•You may be out of range. Move closer to the base.

•Press and release PROG/CHAN to change to another of the 30 channels available. If noise is exceptionally loud, move closer to the base before changing channels.

•Household appliances plugged into the same circuit as the base can sometimes cause interference. Try moving the appliance or the base to another outlet.

16

Page 17 Page 19
Image 18
Page 17 Page 19
Contents Page Contents Important Safety Instructions Before YOU Begin About Caller Identification Caller IDParts Check List Installation Before You InstallTable/Desk Installation Check for dial toneTelephone Operation Telephone Operation Handset Ringer Style/Battery Save Temporary Tone DialingHeadset Jack Operating Range Telephone Memory Store a Number or Name in MemoryEdit a Number/Name Stored in Memory Delete a Number/Name Stored in MemoryDial a Memory Number Telephone Directory Store a Number/Name in the DirectoryEdit a Number/Name Stored in the Directory Delete a Number/Name Stored in the DirectoryDial a Number from the Directory Review Call History Caller ID OperationAbout Call History Delete a Specific CallDial a Displayed Number Store a Call History Record in the DirectoryReplacing the Handset Battery Pack BatteriesCase of Difficulty If the phone does not ring when you receive a callIf you hear noise or interference when using the phone If the phone doesn’t work at all, check these items firstIf you hear other calls while using your phone If you lose a call after changing channelsMaintenance How Long is the limited warranty period ? Warranty StatementWhat does this limited warranty cover? What is not covered by this limited warranty ?Other Limitations FCC and IC Regulations FCC PartIC Industry Canada Rbrc Seal Technical Specifications Rbrc SealIssue
Top Page Image Contents