VTech 6031 important safety instructions To synchronize

Page 41

Troubleshooting

Problem

Suggestion

My cordless handset

• Make sure the power cord is securely plugged into the telephone base. Plug the unit into a

beeps and is not

different working electrical outlet not controlled by a wall switch.

performing normally.

• Move the cordless handset closer to the telephone base. It may be out of range.

 

• Reset the telephone base by unplugging the unit’s electrical power. Wait for 15 seconds and

 

plug it back in again. Allow up to one minute for the cordless handset and the telephone base

 

to synchronize.

 

• Other electronic products can cause interference to your cordless telephone. Try installing

 

your telephone as far away from these electronic devices as possible: wireless routers, radios,

 

radio towers, pager towers, cellular telephones, intercoms, room monitors, televisions, personal

 

computers, kitchen appliances and other cordless telephones.

 

 

Common cure for

• If the unit is not responding normally, try putting the cordless handset in the telephone base.

electronic equipment

If it does not seem to respond, try the following (in the order listed):

 

• Disconnect the power to the telephone base.

 

• Disconnect the battery on the cordless handset.

 

• Wait a few minutes before connecting power to the telephone base.

 

• Re-install the battery and place the cordless handset into the telephone base.

 

• Wait for the cordless handset to synchronize its connection with the telephone base. Allow up

 

to one minute for this to take place.

 

 

38

www.vtechphones.com

Page 40 Page 42
Image 41
Page 40 Page 42
Contents Congratulations Table of contents Table of contents Parts checklist InstallationInstall handset battery Outlet not controlled by a wall switch Telephone base installationDial type Desk/table bracket installationIf you subscribe to DSL service Handset layout Telephone settingsTelephone base layout Telephone settingsBasic operationRing melody Date and timeBattery low tone Ring volumeKey tone Out of range toneLanguage Edit handset nameClear voicemail Temporary tone dialing Reset to default settingsMake, answer and end calls Basic operationOptions while on calls Speakerphone MuteFind handset Directory Advanced operationReview the directory Search the directoryCharacter chart Dial a directory entry Store a directory entryDelete from the directory Edit an entry in the directoryAbout caller ID Review the call log Call logStore a call log number Dial a call log numberTo delete one entry Delete from the call logStore a redial number to the directory RedialReview redial Delete from redial Dial from redialHandset light Handset and telephone base indicatorsTelephone base lights Handset iconsDisplay When Handset display screen messagesPlace in Charger Call log display screen messagesBattery Important safety instructions Problem Suggestion TroubleshootingCharge light is off in this section Not Available For this to take place Your area. See Dial type on page 12 to set the dial type Telephone company charges may apply Company To synchronize Operating range MaintenanceAbout cordless telephones WarrantyHow do you get warranty service? FCC Part FCC, Acta and IC regulationsIndustry Canada Rbrc sealTechnical specifications Index Store a number from the call log  91-001079-080-100 User’s manual
Top Page Image Contents