VTech 917ADX manual Parts Check List

Page 4

Parts Check List:

1 Handset

1 Base unit and AC adaptor Telephone line cord

1 Battery pack

HWall mounting bracket

1 Belt clip

WALL MOUNTING

BRACKET

HANDSET

BASE UNIT

BAlTERY PACK

BELT CLIP

AC

ADAPTOR

TELEPHONE LINE CORD

When using your telephone, please follow these basic safety precautionsto reduce the risk of fire, electric shock or injury to persons:

Read and understandall instructions.

I

Follow all warnings and instructions marked on the product.

Unplug this product from the wall outlet before cleaning. Do not use liquid clean- ers or aerosol cleaners. Use a damp cloth for cleaning.

Do not use this product near water (for ex- ample, near a bath tub, kitchen sink, or swimming pool).

Do not place this product on an unstable cart, stand, or table. The product may fall, causing serious damage to the product.

Slots and openings in the cabinet and the back or bottom are provided for ventila- tion. To protect it from overheating,these openings must not be blocked by placing the product on a bed, sofa, rug, or other similar surface. This product should never be placed near or over a radiator or heat register. This product should not be placed in a built-ininstallation where proper ventilation is not provided.

Th i s product should be operated only from the type of power source indicated on the marking label. If you are not sure of the type of power supply to your home, con- sult your dealer or local power company.

Do not allow anything to rest on the power cord. Do not locate this product where the cord will be abused by persons walking on it.

Never push objects of any kind into this product through cabinet slots as they may touch dangerous voltagk points or short out parts that could res It in a risk of fire or electric shock. Neve1spill liquid of any

kind on the product.

To reduce the risk of electric shock, do not disassemble this product. If sewice or repair work is required, contact VTech Customer Sewice at 1-800-595-9511in the U.S. and at 1-800-267-7377in Canada . Opening or removingcabinet parts other than specified access doors may expose you to dangerous voltages or other risks. Incorrect reassemblingcan cause electric shock when the appliance is subsequentlyused.

Do not overload wall outlets and exten- sion cords as this can result in the risk of fire or electric shock.

Unplug this product from the wall outlet :

0When the power supply cord or plug is damaged or frayed.

0If liquid has been spilled into the product.

0If the product has been exposed to rain or water.

0If the product does not operate normally by following the operating instructions. Adjust only those controls that are covered by the operating instructions, because improper adjustment of other controls may result in damage and will often require extensive work to restore the product to normal operation.

0If the product has been dropped and the cabinet has been damaged.

0If the product exhibits a distinct change in performance.

1Avoid using a telephone (other than a cordless type) during an electrical storm. There may be a remote risk of electric

i

Image 4
Contents T E B l e Using the Intercom During a Phone Call Optional Headset Installation and OperatingProgramming the Ringer Type Turning OFF the Handset Ringer Checking the HAN,DSET RingerParts Check List Isave These Instructions Waste,@llection-. ..or disposal. organization DIFFICULTY.IL L M O U N T I N G Phoneled LOW BATT/MUTE LEDRinger Tion and Operating InstrucUSE LED Volume UP KEY Volume Down KEYSpeakerphone Spkr KEY Making CallsAnswering Calls E R a T I N G I N S T R U C T I O N STo PUT a Call on Hold Using the Intercom / Handset LOCA- TOR Temporary Tone FeatureIf Your Phone Rings During AN Intercom Conversation CallBase Ringer OP Erating I N S T R U C T I O N SControl Using Redial OperationDial Changing ChannelsI N T E N a N C E Taking Care of Your TelephoneHandset does not Ring When YOU Receive a Call YOU Hear Other Calls While Using Your PhonePhone Doesnt Workat ALL No Dial ToneHOW do I Send MY UNIT, in or OUT of WARRANTY? SW Nimbus Avenue BEAVERTON, OregonFCC Part Weight Power RequirementsSpecificationsare Typical and MAY Change Without Notice Frequencycontrol