Mute, Call Transfer | Grandstream Networks GXP11O5 specification

NOTE:

If users hang up the current call while there is call hold on the other line, there will be an audible ring tone indicating a call is on hold. Pick up the handset so users can resume with the call on hold.

Mute

Press the MUTE key to mute/unmute the microphone.

Call Transfer

GXP1100/1105 supports Blind transfer, Attended transfer and Auto-Attended transfer:

1.Blind Transfer:

During the call, press TRAN key and dial the number

Press “#” or SEND key to complete transfer of active call

2.Attended Transfer:

During the call, press “FLASH” key to make another call

The ACTIVE LINE will be put on HOLD automatically

Establish the second call

Press TRAN key

Press FLASH key to transfer the call

Hang up the phone after the call is transferred

3.Auto-Attended Transfer:

Enable “Auto-Attended Transfer” under web GUI->Advanced Settings Page and Click “Update” in the web page

Established call. During the call, press TRAN key

A new line will be brought up and the first call will be automatically placed on HOLD

Enter the number and press SEND key to establish the second call

When the second call is established, press TRAN key again and the call will be transferred

NOTE:

To transfer calls across SIP domains, SIP service providers must support transfer across SIP domains.

3-Way Conferencing

GXP110x can host 3-way conference call by using Multi Purpose Key or FLASH key.

To use Multi Purpose Key establish 3-way conference call, uses need to login the GXP110x web GUI- >Settings->Basic Settings, configure “3-way Conference” to the Multi Purpose Key (see Figure below).

Update from the web GUI and then follow the following steps to host the 3-way conference.

Grandstream Networks, Inc.	GXP1100/1105 User Manual	Page 11 of 34
	Firmware version: 1.0.1.110	Last Updated: 01/2012