G723 Rate |
iLBC Frame Size |
iLBC Payload Type |
Jitter Buffer Type |
Jitter Buffer Length |
Conference URI |
Special Feature |
Encoding rate for G723 codec. By default, 6.3kbps rate is set.
Select “ITU” or “IETF” for
iLBC packet frame size. Default is 20ms. For Asterisk PBX, 30ms might be required.
Payload type for iLBC. Default value is 97. The valid range is between 96 and 127.
Jitter buffer type: Fixed or Adaptive. Default value is Adaptive.
Jitter buffer length. Default value is 300ms. The valid range is between 100ms and 800ms.
Configure the conference URI when using Broadsoft
Default is Standard. Choose the selection to meet special requirements from Soft Switch vendors.
SAVING THE CONFIGURATION CHANGES
After the user makes a change to the configuration, press the “Update” button in the Configuration Menu. We recommend rebooting or powering cycle the IP phone after saving changes.
REBOOTING THE PHONE REMOTELY
Press the “Reboot” button at the bottom of the configuration menu to reboot the phone remotely. The indicator on the top right corner will first turn orange and then red. Wait until the indicator is off. Then log in again.
Grandstream Networks, Inc. | GXP1100/1105 User Manual | Page 31 of 34 |
| Firmware version: 1.0.1.110 | Last Updated: 01/2012 |