4.2MWI(Message Waiting Indication)
This LED will flash to indicate a new voicemail. Pressing the MWI key will access the voicemail if the key has been configured correctly.
4.3Redial / Unredial
If B is on a call when A calls, A will get busy tone. If A wants to connect to B as soon as B is available, he can use the redial function. To use this feature, A dials a prefix and then B’s number.
When the redial function is activated, A will check B’s calling status every 60 seconds. When B is available, A’s phone will ring. When A goes off hook, the phone will call B automatically. If A does not want to call B, the redial function can be cancelled by dialing a prefix plus B’s number.
*3* is the redial prefix code. A can dial *3* plus B’s phone number to activate the redial function.
*4* is the unredial prefix code. A can dial *4* to cancel the redial function. The user can select any prefix as long as it does not interfere with dialing rules.
4.4Click to dial
If User A browses to User B’s phone number or SIP address in the contact page and clicks it, User A’s phone will ring. After he goes off hook, the phone will call User B.
Note：This feature requires that the PBX support click to dial.
4.5Auto answer
If this feature is activated, the phone will answer incoming calls after a programmable delay.
5 Web Configuration
5.1Introduction of configuration
5.1.1Configuration Methods
There are three methods which can be used to configure this phone:
Phone keypad – As discussed in previous sections
Web browser - Recommended way
Telnet with CLI command
-12 -