| If this is blank the phone will use anonymous. | |
|
| |
Password | Password for configuration server. Used for FTP/HTTP/HTTPS. | |
|
| |
Config Encryption Key | Encryption key for the configuration file | |
|
| |
Common Config | Encryption key for common configuration file | |
Encryption Key |
|
|
|
|
|
| DHCP Option Settings |
|
|
| |
Field Name | Explanation | |
DHCP Option Setting | The phone supports configuration from Option 43, Option 66, or a | |
| Custom DHCP option. It may also be disabled. | |
|
| |
Custom DHCP Option | Custom option number. Must be from 128 to 254. | |
|
|
|
| Plug and Play Settings |
|
|
| |
Enable PnP | If this is enabled, the phone will send SIP SUBSCRIBE messages to | |
| a multicast address when it boots up. Any SIP server understanding | |
| that message will reply with a SIP NOTIFY message containing the | |
| Auto Provisioning Server URL where the phones can request their | |
| configuration. |
|
|
|
|
PnP Server | PnP Server Address |
|
|
|
|
PnP Port | PnP Server Port |
|
|
| |
PnP Transport | PnP Transfer protocol – UDP or TCP | |
|
| |
PnP Interval | Interval time for querying PnP server. Default is 1 hour. | |
|
|
|
| Phone Flash Settings |
|
|
| |
Server Address | Set FTP/TFTP/HTTP server IP address for auto update. The address | |
| can be an IP address or Domain name with subdirectory. | |
|
| |
Protocol Type | Specify the Protocol type FTP, TFTP or HTTP. | |
|
|
|
Config File Name | Specify configuration file name. | The phone will use its MAC ID |
| as the config file name if this is blank. | |
|
|
|
Update Interval | Specify the update interval time. | Default is 1 hour. |
|
|
|
Update Mode | 1. Disable – no update |
|
| 2. Update after reboot – update only after reboot. | |
| 3. Update at time interval – update at periodic update interval | |
|
|
|
5.3.6.2Syslog
Syslog is a protocol used to record log messages using a client/server mechanism. The Syslog server receives the messages from clients, and classifies them based on priority and type. Then these messages will be written into a log by rules which the administrator has configured. There are 8 levels of debug information.
- 43 -