Cisco Systems 3600 manual Voice over IP Configuration Examples, FXS-to-FXS Connection Using Rsvp

Voice over IP Configuration Examples

Configure Microsoft NetMeeting for Voice over IP

To configure NetMeeting to work with Voice over IP, complete the following steps:

Step 1 From the Tools menu in the NetMeeting application, select Options. NetMeeting will display the Options dialog box.

Step 2 Click the Audio tab.

Step 3 Click the “Calling a telephone using NetMeeting” check box.

Step 4 Enter the IP address of the Cisco AS5300 in the IP address field.

Step 5 Under General, click Advanced.

Step 6 Click the “Manually configured compression settings” check box.

Step 7 Select the CODEC value CCITT ulaw 8000Hz.

Step 8 Click the Up button until this CODEC value is at the top of the list.

Step 9 Click OK to exit.

Initiate a Call Using Microsoft NetMeeting

To initiate a call using Microsoft NetMeeting, perform the following steps:

Step 1 Click the Call icon from the NetMeeting application. Microsoft NetMeeting will open the call dialog box.

Step 2 From the Call dialog box, select call using H.323 gateway.

Step 3 Enter the telephone number in the Address field.

Step 4 Click Call to initiate a call to the Cisco 3600 series router from Microsoft NetMeeting.

1

Voice over IP Configuration Examples

The actual Voice over IP configuration procedure you complete depends on the actual topology of your voice network. The following configuration examples should give you a starting point. Of course, these configuration examples would need to be customized to reflect your network topology.

Configuration procedures are supplied for the following scenarios:

These examples are described in the following sections.

FXS-to-FXS Connection Using RSVP

The following example shows how to configure Voice over IP for simple FXS-to-FXS connections.

In this example, a very small company, consisting of two offices, has decided to integrate Voice over IP into its existing IP network. One basic telephony device is connected to Router RLB-1; therefore Router RLB-1 has been configured for one POTS peer and one VoIP peer. Router RLB-w and Router

VC-38Voice, Video, and Home Applications Configuration Guide