Configure Voice over IP for Microsoft NetMeeting
Configure a Trunk Connection
To configure virtual trunk connections in a VoIP network, use the following commands beginning in global configuration mode:
Step | Command | Purpose |
1 | Enter | |
|
| number for a POTS dial peer. |
|
|
|
2 |
| Specify the telephone number associated with the |
|
| POTS dial peer. |
|
|
|
3port
4 | Define a tag number for a VoIP dial peer. |
5session target
6 |
| Identify the destination pattern (telephone number) |
|
| of the VoIP dial peer call leg on the destination end |
|
| router. |
|
|
|
7 | exit | Exit |
|
|
|
8 | configure terminal | Enter global configuration mode. |
|
|
|
9 | Enter | |
|
| |
|
|
|
10 | connection trunk string | Specify a straight |
|
| connection). The string argument refers to the |
destination pattern (telephone number) configured for the destination VoIP dial peer. The value you configure for the connection trunk command must exactly match the value configured for the VoIP dial peer.
Note This configuration must be performed on both end routers for the trunk connection to be established.
Configure Voice over IP for Microsoft NetMeeting
Voice over IP can be used with Microsoft NetMeeting (Version 2.x) when the Cisco 3600 or Cisco 2600 series router is used as the voice gateway. Use the latest version of DirectX drivers from Microsoft on your PC to improve the voice quality of NetMeeting.
Configure Voice over IP to Support Microsoft NetMeeting
To configure Voice over IP to support NetMeeting, create a VoIP peer that contains the following information:
•
•
Session
Configuring Voice over IP for the Cisco 3600 Series