Cisco Systems 3600 manual Pstn Gateway Access Using FXO Connection Plar Mode

Page 34

Voice over IP Configuration Examples

Configuration for Router SLC

!Configure pots dial peer 1 dial-peer voice 1 pots

destination-pattern 9...........

port 1/0/0

!Configure voip dial peer 2

dial-peer voice 2 voip destination-pattern +14085554000 session target ipv4:172.16.1.123

!Configure serial interface interface serial 0/0

ip address 172.16.65.182 no shutdown

PSTN Gateway Access Using FXO Connection (PLAR Mode)

The following example shows how to configure Voice over IP to link users with the PSTN Gateway using an FXO connection (PLAR mode).

In this example, PSTN users in Salt Lake City, Utah, can dial a local number and establish a private line connection in a remote location. As in the previous example, Router SLC in Salt Lake City is connected directly to the PSTN through an FXO interface.

Figure 15 illustrates the topology of this connection example.

Figure 15 PSTN Gateway Access Using FXO Connection (PLAR Mode)

 

 

PLAR connection

 

 

IP cloud

 

Router SJ

Router SLC

1(408) 555-4000

 

 

172.16.1.123

172.16.65.182

San Jose

Voice port

Voice port

 

 

1/0/0

1/0/0

PSTN user

PSTN

cloud

Salt Lake City

S6618

 

Note This example assumes that the company already has established a working IP connection between its two remote offices.

VC-46Voice, Video, and Home Applications Configuration Guide

Image 34 Contents
Configuring Voice over IP for the Cisco 3600 Series How Voice over IP Processes a Telephone CallList of Terms Prerequisite Tasks Voice over IP Configuration Task List Configure IP Networks for Real-Time Voice Traffic VC-18Voice, Video, and Home Applications Configuration Guide Configure Multilink PPP with Interleaving Step Command PurposeConfigure RTP Header Compression Multilink PPP Configuration ExampleRTP Header Compression Configuration Example Enable RTP Header Compression on a Serial InterfaceChange the Number of Header Compression Connections Configure Custom Queuing Configure Frame Relay for Voice over IPConfigure Weighted Fair Queuing Frame Relay for Voice over IP Configuration Example Configure Number Expansion Create a Number Expansion TableConfigure Number Expansion Shows the number expansion table for this scenarioConfigure Dial Peers Inbound versus Outbound Dial PeersInbound versus Outbound Dial Peers Create a Peer Configuration Table CodecOutbound Dialing on Pots Peers Configure Pots PeersDirect Inward Dial for Pots Peers Incoming and Outgoing Pots Call Legs Configure VoIP Peers Troubleshooting Tips Optimize Dial Peer and Network Interface ConfigurationsConfigure IP Precedence for Dial Peers Validation TipsConfigure Rsvp for Dial Peers Configure Codec and VAD for Dial Peers Configure Codec for a VoIP Dial PeerConfigure Voice over IP using a Trunk Connection Configure VAD for a VoIP Dial PeerVC-36Voice, Video, and Home Applications Configuration Guide Configure Voice over IP for Microsoft NetMeeting Configure a Trunk ConnectionVoice over IP Configuration Examples FXS-to-FXS Connection Using RsvpConfiguration for Router RLB-1 FXS-to-FXS Connection ExampleVC-40Voice, Video, and Home Applications Configuration Guide Configuration for Router RLB-w Configuration for Router R12-eConfiguration for Router RLB-2 Configuration for Router SJ Linking PBX Users with E&M Trunk LinesConfiguration for Router SLC Pstn Gateway Access Using FXO Connection Pstn Gateway Access Using FXO Connection ExamplePstn Gateway Access Using FXO Connection Plar Mode Pstn Gateway Access Using FXO Connection Plar ModeConfiguring Voice over IP for the Cisco 3600 Series VC-47 VC-48Voice, Video, and Home Applications Configuration Guide
Related manuals
Manual 10 pages 46.09 Kb Manual 52 pages 58.61 Kb Manual 18 pages 19.61 Kb Manual 16 pages 56.75 Kb Manual 24 pages 16.63 Kb Manual 36 pages 49.11 Kb