Chapter 45 Cisco IP Phone Configuration
Configuring Cisco IP Phones
To display the MAC address when the phone is powered on, refer to the Cisco IP Phone documentation that supports your phone model. The following examples show steps that you may perform for the Cisco IP Phone models 12 SP+ and 30 VIP or Cisco VG248 phone ports:
•Cisco IP Phone models 12 SP+ and 30
•Cisco VG248 phone
Related Topics
•Cisco IP Phone Configuration, page
•Gateway Configuration, page
•Adding a Phone, page
•Updating a Phone, page
•Cisco IP Phones, Cisco CallManager System Guide
•Phone Configuration Checklist, Cisco CallManager System Guide
Adding a Phone
Before a Cisco IP Phone can be used, you must use this procedure to add the phone to Cisco CallManager. You can also use this procedure to configure H.323 clients, CTI ports, Cisco ATA 186 telephone adapter, or the Cisco VG248 Analog Phone Gateway (each of the 48 ports is recognized and configured as a phone). H.323 clients can be Symbol NetVision phones or Microsoft NetMeeting clients. CTI ports designate virtual devices that Cisco CallManager applications such as Cisco SoftPhone and Cisco AutoAttendant use.
Note If you are planning to use a TAPI application to control CTI port devices that are using the Cisco TAPI Service Provider (TSP), then you may only configure one line per CTI port device.
| Cisco CallManager Administration Guide |
|