studs or cross members), partially screw the two screws into the wall at the marks, remove them, hang the tabs on the screws, and then tighten the screws.
For plaster, plasterboard, cinder block, or brick surfaces, drill a 3/16" hole at each mark and insert an anchor into each of the holes. Gently tap each anchor with a ham- mer until it is flush with the surface. Screw the screws partially into the anchors, remove them, hang the tabs on the screws, and then tighten the screws.
Step 2 — Connect the SPIRIT Attendant ConnecT/R to the controller and the SPIRIT
Attendant to the SPIRIT Attendant
ConnecT/R.
Please check the cabling requirements in Appen- dix A before proceeding. Consult with the person who customized your SPIRIT System before attaching the SPIRIT Attendant ConnecT/R to the controller.
NOTE: The
5