I N S T A L L A T I O N
AC Adapter
PULSE/TONE Switch
Modular Jack
Power Cord | Telephone Line Cord |
|
FOR TABLE/DESK INSTALLATION
1Choose a spot near an electrical outlet and a telephone jack. This phone requires a modular telephone jack and a standard electrical outlet (110v AC).
2Install the handset battery.
For an illustration of battery installation, see BATTERIES.
•Plug the battery pack connector into thehandset and place the battery pack into the case, so the wires rest between the battery pack and the case.
•Place the battery case cover on the handset by sliding it on its track up over the battery case until it snaps firmly in place.
3Install the handset antenna.
Screw the antenna into the opening at the top of the handset.
4Connect the telephone line cord.
Plug one end of the telephone line cord into the jack on the back of the base. Plug the other end of the line cord into a modular phone jack. Make sure the plug snaps firmly in place.
5Connect the power cord.
Plug the power cord into the POWER jack on the back of the base. Plug the AC adapter on the power cord into an electrical outlet.
6Charge the handset batteries for 10 hours before use. Place the handset face up or face down in the base if your phone is installed on a table. Place the handset
face down in the base if your phone is installed on a wall. (The handset charges only
7Check for dial tone.
After the batteries are charged, pick up the handset and make sure the base antenna is upright. Check for dial tone by pressing P; the PHONE light should go on and you should hear a dial tone.
8Set the dial mode.
If you have touch tone service, the phone will be ready to use as soon as the battery is charged.
NOTE: If you have dial pulse service, you’ll need to set the dial mode. Set the PULSE/TONE switch on the back of the base to PULSE.
CAUTION: Use only the AC power adapter supplied with this telephone. Power Supply 4000T. Input: AC 120v, 600 Hz, 4.7W Output: 120 VDC, 200 mA.
1