AT&T CL81201, CL82551 Adding and registering handsets, Register a handset to your telephone base

Registration and deregistration

Adding and registering handsets

Before using a new CL80101 handset, you must register it with the AT&T CL81101/CL81201/CL81301/CL82101/CL82201/CL82301/CL82351/ CL82401/CL82451/CL82501/CL82551/CL82601 telephone system (purchased separately). The telephone system can support up to 12 handsets.

The handsets provided with your telephone system are already registered as HANDSET 1 and so forth. Additional handsets registered to the telephone system are assigned in sequential order they are registered (up to HANDSET 12).

You must register each handset separately. When first purchased, all expansion handsets show Put HS on BASE to register.

Register a handset to your telephone base
1.	Make sure the handset is out of the telephone
		Put HS on BASE
	base or charger and shows Put HS on BASE to
		to register
	register before you begin registration.
2.	Put the handset you wish to register on the
	telephone base cradle.

3. The screen shows Registering... Please wait	Registering...
and the IN USE light turns on. It takes up to 90	Please wait
seconds to complete registration. Then
HANDSET X Registered appears on the screen,
with HANDSET being the handset name and X
	HANDSET X
being the handset number (1-12). The handset
	Registered
beeps and the IN USE light turns off. The handset
is now registered with the telephone base.
If registration fails, Registration failed appears on the
screen. Start again from Step 1 above.

NOTES:

•You cannot register a handset if any other system handset is in use.

•To reset the telephone, unplug the power and the battery for a few seconds then plug them back in.