AT&T 9230 user manual Installation, Before You Install

Page 5

INSTALLATION

Before You Install

1Choose a location for the base near an electrical outlet and a telephone jack.

This phone requires a modular telephone jack and a standard electrical outlet (110v AC) not controlled by a wall switch.

2Install the handset battery.

a)	Remove battery
	compartment
	cover by pressing
	on the
	indentation
	and sliding
	downward.
	b)	Plug battery pack
		connector into
		handset. Use only
		AT&T battery 3301
		(SKU#91076).
c)	Place battery pack
	and wires in
	compartment.
d)	Replace
	cover by
	sliding it up
	into place.

4

Image 5

Contents MHz Cordless Telephone With Caller ID/Call Waiting Advanced American Telephones. All rights reserved Contents About Caller Identification Caller ID Before YOU BeginBefore You Install InstallationCheck for dial tone Table/Desk InstallationWall Installation Time/Date Feature SettingsRinger Selection Auto Answer On/OffTelephone Operation Handset Locator Headset Jack Display Screen Messages Operating RangeStore Memory Numbers Telephone MemoryDelete Numbers Stored in Memory Edit Numbers Stored in MemoryMove Numbers Stored in Memory Delete a Specific NumberDial Memory Numbers Caller ID Operation Review Call History About Call HistoryDial a Displayed Number Delete Call HistoryDelete a Specific Call Delete All CallsTo LOCATION? Store Call in MemoryTurn Off Call Block Call BlockPrivate Name Batteries Charging the Handset Battery PackReplacing the Handset Battery Pack If the phone doesn’t work at all, check these items first If the phone does not ring when you receive a callCase of Difficulty If you lose a call after changing channels If you hear noise or interference when using the phoneIf you hear other calls while using your phone