AT&T 9311 user manual Installation, Before You Install, Install the handset battery

Page 5

INSTALLATION

Before You Install

1Choose a location for the base near an electrical outlet and a telephone jack.

This phone requires a modular telephone jack and a standard electrical outlet (110v AC) not controlled by a wall switch.

2Install the handset battery.

a)Remove battery compartment

cover by pressing on the indentation

and sliding downward.

b) Align two holes in plug with socket pins, and snap the plug into place.

c)Place battery pack in compartment

with the wires in the lower left corner, along the bottom of the battery pack.

d) Replace cover by sliding it up into place.

3

Image 5

Contents Part 1 Important Product Information MHz Cordless Telephone Advanced American Telephones. All rights reserved Contents Page Install the handset battery InstallationBefore You Install Attach the belt clip to the cordless handset optional Check for dial tone Table/Desk InstallationSet the dial mode Position the wall mount adapter on the base Wall InstallationConnect the telephone line cord Connect the power cord Mount the base on the wall Follow Steps 3-5 in Table/Desk InstallationTelephone Operation Telephone Operation Handset Ringer Style Ringer Off/Battery SaveTemporary Tone Dialing Operating Range Headset JackTelephone Memory Batteries Charging the Handset Battery PackReplacing the Handset Battery Pack If the phone doesn’t work at all, check these items first If the phone does not ring when you receive a callCase of Difficulty If you lose a call after changing channels If you hear noise or interference when using the phoneIf you hear other calls while using your phone