AT&T 9311 user manual Batteries, Charging the Handset Battery Pack

Page 15

BATTERIES

Charging the Handset Battery Pack

This battery should remain charged up to six days with the ringer turned on and up to 12 days with the ringer off. A fully charged battery provides an average talk time of about six hours.

The battery pack needs charging when:

A new battery is installed in the handset.

The phone beeps twice when you press P.

The phone light flashes slowly.

Place the handset in the base so the CHARGING light turns on. The battery pack is typically fully charged in eight hours.

You can keep the battery fully charged by returning the handset to the base after each use.

If you repeatedly get a low battery indicator, even after eight hours of charging, the battery should be replaced.

CAUTION: To reduce the risk of fire or injury to persons or damage to the telephone, read and follow these instructions carefully:

Use only Replacement Battery 3301 (SKU# 91076).

Do not dispose of the battery in a fire. The cell might explode. Check with local codes for special disposal instructions.

Do not open or mutilate the battery. Released electrolyte is corrosive and may cause damage to the eyes or skin. It may be toxic if swallowed.

Exercise care in handling batteries in order not to short the battery with conducting materials such as rings, bracelets, and keys. The battery or conductor may overheat and cause harm.

Charge the battery provided with or identified for use with this product only in accordance with the instructions and limitations specified in this manual.

Observe proper polarity orientation between the battery and battery charger.

13

Image 15
Contents Part 1 Important Product Information MHz Cordless TelephoneAdvanced American Telephones. All rights reserved Contents Page Installation Before You InstallInstall the handset battery Attach the belt clip to the cordless handset optional Table/Desk Installation Set the dial modeCheck for dial tone Wall Installation Connect the telephone line cord Connect the power cordPosition the wall mount adapter on the base Mount the base on the wall Follow Steps 3-5 in Table/Desk InstallationTelephone Operation Telephone Operation Ringer Off/Battery Save Temporary Tone DialingHandset Ringer Style Operating Range Headset JackTelephone Memory Batteries Charging the Handset Battery PackReplacing the Handset Battery Pack If the phone does not ring when you receive a call Case of DifficultyIf the phone doesn’t work at all, check these items first If you hear noise or interference when using the phone If you hear other calls while using your phoneIf you lose a call after changing channels