Standard power outlet
1Setting up the Cordless Telephone 9111.
Choose an area near an electri-
cal outlet and a telephone jack. The outlet should not be controlled by a wall switch.
2Connect the telephone line cord. 
Insert one end of the telephone line cord into the jack at the
rear of the base unit. Plug the other end into a telephone jack. Make sure the plugs snap securely into place.
3Connect the power cord.
Plug the AC power adapter into a standard electrical outlet and the DC connector into the power jack located at the
rear of the base unit.
Wrap the power cord around the strain relief hook on the bottom of the base unit (see illustration). The strain relief hook helps protect the power cord from accidentally being removed.
CAUTION: Use only the AC power adapter supplied with this telephone. This is a Class 2 AC adapter, specifi- cally designed for use with the 9 111.
NOTE: Connect power to the base unit before placing the handset in the cradle.
4Set the dial mode switch.
If you have touch tone service on your phone line, set the switch located on the bottom of the base to TONE. If you have rotary service, set the switch to PULSE.
5Install the handset battery.
Remove the handset battery cover by pressing the indentation on the handset battery cover and sliding the cover downward.
INSTALLATION
Clips
Place the handset battery pack in the compartment. Make sure the metal contacts on the underside of the battery are aligned with the charging contacts in the handset battery compartment.
Replace the handset battery cover by sliding it on its track up and over the handset battery compartment until it snaps firmly in place.
6Charge the handset batteries before use.
Place the handset in the base unit cradle either in the face up or face down position. Make sure that the
Telephonejack
Slots
Base unit
Tabs
base
IN USEICHARGE light on the base is on. The handset battery must be charged a minimum of
6 hours before using your phone for the first time. The batteries recharge automatically whenever the handset is placed in the base unit cradle.
7Check for dial tone.
After the batteries are charged,
pick up the handset and press m.The PHONE indicator should light up, and you should hear a dial tone. If not, see "IN CASE OF DIFFICULTY in this manual.
1