CAUTION:
Never install telephone wiring during a lightning storm.
Never install telephone jacks in wet locations unless the jack is specifically designed for wet locations.
Never touch uninsulated telephone wires or terminals unless the tele- phone line has been disconnected at the network interface.
Use caution when installing or modifying telephone lines.
=mum
Choose a spot where the telephone wall jack is near an electrical outlet.
This phone requires a modular telephone jack and a standard electrical outlet (120V AC).
Remove the reversible base.
The reversible base is designed for
1 Press | Mimaw |
on the handset and |
wait for the PHONE indicator to go on.
2When you hear a dial tone, dial the number.
NOTE: When another extension is in use on the same line, and the Cordless Telephone 9 111 is in standby mode, the PHONE indicator on the handset will flash. The IN USEICHARGE indicator will not function when the handset is out of range.
llrrsnralngaw
If the handset is in the base:
NOTE: The IN USEICHARGE indicator will increase intensity with the incoming ring.
INSTALLATION
continued
both table and wall mount installa- tions. The telephone comes with the reversible base installed in the table mount position. To wall mount this telephone you will need to remove the reversible base and position it so that the thicker end is toward the front of the telephone (see illustration on previous page). You can remove the reversible base by depressing the clips on each side of the base while gently lifting upwards.
3Reattach the reversible base.
Insert the tabs of the reversible base into the slots on the bottom of the telephone base.
Gently press the thicker end of the reversible base until it snaps firmly in place.
4Connect the telephone line cord.
Using the short telephone line cord supplied, insert one end of
1 Lift the handset.
2The PHONE indicator goes on and the call will be connected.
If the handset is away from the base:
NOTE: The IN USEICHARGE indicator will flash with each incoming ring.
Press any key on the handset (except (MUTEI, a, or m)This. is very useful in a dark environment; you do not have to fumble around looking
for the | key to answer the call. |
tmmJgd(
1 Plug the headset (purchased separately) into the jack located on the right side of the handset. (For best results, use only an accessory headset with a 2.5 rnrn plug.)
the telephone line cord into the telephone jack on the rear of the telephone base.
Feed the remaining line cord to the rectangular opening by pressing the line cord into the grooves of the reversible base leaving at least 3 inches free. Plug the line cord into the standard wall jack.
5Connect the power cord.
Plug the power cord into the jack on the back of the base. Plug the AC adapter into an electrical outlet.
6Mount the telephone to the wall jack.
Position the telephone base so the mounting studs on the wall jack fit into the reversible base. Slide the telephone down on the mounting studs until the phone locks in place.
.
2Follow instructions under "Making a Call" or "Answering a Call."
NOTE: The earpiece and micro- phone on the handset are disabled when the headset is plugged in. A belt clip is included for your convenience (see INSTALLATION).
If you are near the base:
Place the handset in the base.
If you are away from the base:
Press [OFF].
lbhIll0colmd
The Volume Control allows you to increase or decrease the loudness of an incoming voice.
3